Marbletrend Madeira Basin Mixer User manual

INSTALLATION INSTRUCTIONS
Basin and Sink Mixers
Model
Code
Taphole
diameter
mm
Max bench
thickness
mm
Madeira Basin Mixer
MTM121
35
45
Madeira Tall Basin Mixer
MTM223
35
45
Madeira Sink Mixer Curved Form
MTM403
35
43
Madeira Sink Mixer Square Form
MTM423
35
40
Sardina Basin Mixer
MTS121
35
45
Sardina Tall Basin Mixer
MTS223
35
45
Sardina Sink Mixer Curved Form
MTS403
35
43
Sardina Sink Mixer Square Form
MTS423
35
40
Congratulations on your purchase of Marbletrend tapware, we are confident that this
quality product will serve you reliably for many years.
These instructions apply to the following products:
Flexi-hoses
Base-nut
Bench/Basin top
Threaded
base
Base flange
with O-ring
Rubber
gasket
Mixer body
Cover button
Aerator
Component diagram Lever handle

Care and maintenance
Occasional cleaning with a soft cloth and warm soapy water is all that is needed to keep your
tapware in good condition. Do not use harsh or abrasive cleaning agents.
Depending upon local water quality the aerator may need occasional cleaning. Simply
unscrew the aerator using a broad-bladed screwdriver and clean by rinsing in fresh water.
Should it become necessary to change the ceramic cartridge this can be done by first
removing the chrome cover-button and then inserting a 2.5mm allen key to loosen the internal
grub screw - the lever handle can then be removed giving access to the cartridge assembly.
Both the hot and cold water supplies must be turned off before doing this.
Operating conditions:
Pressure 0.05-1.0 Mpa
Temperature 4 - 90°C
INSTALLATION INSTRUCTIONS
Madeira and Sardina Basin and Sink Mixers
Installation procedure
1. Check installation position and bench or basin thickness prior to starting
2. If necessary drill a 35mm diameter hole in the benchtop for the mixer body
3. On some models the flexi-hoses must be fitted to the mixer body before installation. In this
case the threaded base, base flange, rubber gasket and base-nut will also be packed
separately. Before fitting the flexi-hoses insert the male end of the hoses through the
threaded base and the base flange and O-ring then tighten the flexi-hoses by hand ensuring
that the rubber O-ring seal is compressed.
4. Fit the base flange with O-ring onto the mixer body
5. Insert the flexi-hose tails and threaded base section through the fitting hole
6. Fit the rubber gasket and screw up the base nut to tighten the assembly
7. Flush the hot and cold supply pipes to remove any construction debris
8. Attach the hot and cold flexi-hoses to their respective connections
9. Turn the water supplies on and check for leaks and tap operation.
WARRANTY
This tapware carries a Product Replacement warranty against defects that
appear within a period of 5 years and a Parts and Labour warranty for a 2
year period. The Warranty commences from the date of purchase.
In Australia, consumers are protected from the consequences of faulty or
defective products by the Australia Competition and Consumer Act.
Products must be fit for purpose and free from material and manufacturing
defects.
Please go to www.marbletrend.com.au for full warranty terms and conditions.
CONTACT
Tel [phone]
[email protected]
www.marbletrend.com.au
LIC.WM-022191
R1.1