Markes International TubeTAGPLUS User manual

QUI-1046 TAG Read Kit Installation 1
TubeTAG
PLUS TM
Installation Manual
Version 1.2
December 200
Note: Operators instructions can be found on the Technical CD supplied with the
U LTR A (50:50)

QUI-1046 TAG Read Kit Installation 2
Switch power off to ULTRA (50:50)
Remove the covers from ULTRA (50:50).
Loosen the 2 bolts holding the oven
securing plate in place.
Raise the securing plate and retighten
the 2 bolts.
ULTRA 50:50 only - Loosen the white
thumb screw then tilt the fan backwards.
Loosen the 2 screws highlighted.

QUI-1046 TAG Read Kit Installation 3
Tilt the tube oven assembly towards the
rear of the instrument.
Feed the connector and wire from the
TAG reader through the opening
highlighted.
Feed the TAG reader plate through the
opening shown.

QUI-1046 TAG Read Kit Installation 4
Locate the plate on the 2 loosened
screws.
The heat and sensor plate needs to be
replaced on system with serial no. before
(GB00)M30764.
To remove the plate first disconnect the
sensor by carefully pulling out the
connector.
The plate can then be lifted out.

QUI-1046 TAG Read Kit Installation 5
Insert the plate supplied with the TAG
PLUS
kit ensuring it sits flat in the groove.
Attach connector to the sensor.
Tilt the tube oven back in place and
secure the TAG reader plate.
On U LTR A (50:50) with serial no.
(GB00)M2
Mount the TAG PCB on the rear left of
the instrument as shown.
Note: Ensure board does not contact
the control PCB

QUI-1046 TAG Read Kit Installation 6
On U LTR A (50:50) with serial no.
(GB00)M3
Mount the TAG PCB on the rear left of
the instrument on the mounting plate
highlighted.
Plug the ribbon cable and TAG reader
connector into the PCB.
Secure any loose wires with cable ties.
Replace all covers.