MARLINK SMALLTRACK Installation instructions manual

Technical characteristics :
1) Dimensions: 123,5 x 76 x 33 mm (L x W x D), without bracket and cable
2) Weight: 440g
3) External power supply: Input DC 6-42V (1A)
4) Internal battery: Rechargeable 1800mAH Li-ion battery
5) Internal antennas Iridium, GPS
6) 3 axis G-force sensors : Inclinometer and accelerometer
Kit composition :
1) Smalltrack bracket –APR4072
2) Smalltrack power cable –APR4080
3) Antenna Iridum 3m (car/SSV), 5m (truck) –APR4053/4056
4) GPS antenna –APR2861
5) GPS cable 3m (car/SSV), 5m (truck) –APR4030/4032
114/126, avenue d’Alfortville –94600 CHOISY LE ROI –France
Tél : [phone] - Fax : [phone]
S.A.S. au capital de 236 400€ - Code TVA FR 26 334 306 172 –Code APE 6130 Z - SIREN 334 306 172 00084 –
RC 334 306 172 www.marlink.com - services.[email protected]
1
SMALLTRACK MOUNTING GUIDE
CAR –SSV - TRUCK
1
2
3
45

The power cable must be directly connected to the battery or fuse box with permanent power supply
(no breaker –fuse 3A).
If the configuration of your vehicle doesn’t enable it, you can connect your power cable to a power
extension as shown below (available on our e-shop APR4033) :
1) Prepare your Smalltrack power cable separating the red wire from the black
2) Connect the power extension cable (direct battery) with the Smalltrack power cable using terminals
provided :
- red wire avec red wire
- black with black
3) Use a plier for the connection
4) Connect the power extension cable to the battery, red wire on +12V/+24V (red terminal) and the
black wire on the negative pole.
5) Connect the fuse
114/126, avenue d’Alfortville –94600 CHOISY LE ROI –France
Tél : [phone] - Fax : [phone]
S.A.S. au capital de 236 400€ - Code TVA FR 26 334 306 172 –Code APE 6130 Z - SIREN 334 306 172 00084 –
RC 334 306 172 www.marlink.com - [e-mail]
2
1
2
1 2
3 4 5
POWER SUPPLY

Total height of the Smalltrack in the bracket is 50mm (29mm for bracket only).
SMALLTRACK FIXATION
Recommended solution : bracket fixed to the navigation board by the 4 fixation points with use of
external GPS & Iridium antennas (page 4) →same antennas as Iritrack.
Alternative solution: fixation in proximity with the windscreen →no external antennas
Setup subject to validation by the Marlink staff on the Rally.
114/126, avenue d’Alfortville –94600 CHOISY LE ROI –France
Tél : [phone] - Fax : [phone]
S.A.S. au capital de 236 400€ - Code TVA FR 26 334 306 172 –Code APE 6130 Z - SIREN 334 306 172 00084 –
RC 334 306 172 www.marlink.com - [e-mail]
3
You must have access to the buttons easily
BRACKET

Magnetic antennas must be installed horizontally and clear of all obstacles at 180 degrees
towards the sky, either on the roof or bonnet of the vehicle (metal surface).
GPS and Iridium antennas can be side by side. It is forbidden to paint or integrate them into the
core of the vehicle.
Connect the GPS cable to the GPS antenna and bring the GPS connector to the bracket.
Then, bring the Iridium connector to the bracket.
WARNING :
- The antenna cables should not go through the door seals but in the walls of the vehicle or via a
cable gland.
- It is very important to put a shrinkable tube on each antenna / cable to couple them. Before
heating the shrinkable tube, make sure the connectors are properly locked.
114/126, avenue d’Alfortville –94600 CHOISY LE ROI –France
Tél : [phone] - Fax : [phone]
S.A.S. au capital de 236 400€ - Code TVA FR 26 334 306 172 –Code APE 6130 Z - SIREN 334 306 172 00084 –
RC 334 306 172 www.marlink.com - [e-mail]
4
ANTENNAS AND CABLES