Marson MR15 User manual

1
MR15 User’s Manual V1.0
MR15
Fixed Android UHF Reader
User’s Manual

2
MR15 User’s Manual V1.0
Table of Content
Chapter 1 Product Intro ..........................................................................................................3
1.1 Intro...........................................................................................................................3
1.2 Interface ....................................................................................................................4
1.3 Accessory List ...........................................................................................................5
1.4 Device installation......................................................................................................6
Chapter 2 UHF demo ..............................................................................................................7
2.1 Operating Interface...................................................................................................7
Chapter 3 UHF tag scanning ..................................................................................................9
3.1 Auto Scanning ...........................................................................................................9
3.2 Single Scanning ......................................................................................................11
3.3 Read UHF Tag ........................................................................................................12
3.4 Write Tag.................................................................................................................14
3.5 Lock Tag .................................................................................................................15
3.6 Kill Tag ....................................................................................................................17
3.7 UHF Module Version ...............................................................................................18
3.8 Module Temperature ...............................................................................................19
Chapter 4 Config...................................................................................................................20
4.1 Working mode .........................................................................................................20
4.2 Output Power ..........................................................................................................21
4.3 R2000 settings ........................................................................................................22
4.4 Protocol ...................................................................................................................23
4.5 RF link .....................................................................................................................24
4.6 QT Tag ....................................................................................................................25
4.7 Open tagFocus........................................................................................................26
4.8 Open FastID............................................................................................................26
4.9 Open EPC and TID .................................................................................................26
4.10 WWAN Specification ...............................................................................................26
Chapter 5 SIMPLIFIED EU DECLARATION OF CONFORMITY............................................27
Chapter 6 Warning ................................................................................................................28

3
MR15 User’s Manual V1.0
Chapter 1 Product Intro
1.1 Intro
MR15 is a 4-channel fixed RFID reader, based on Android 9.0.
Integrated with Impinj R2000 RFID chip, it supports RS232, RJ45 and
HDMI, and can be compatible with various types ofantennas. With
high stability and outstanding performance, MR15 can be ideally
applied to warehouse management, archives and library
management, bank, clothing and footwear retail, jewelry monitoring,
watch industry, laundry, production line management, medical
instrument cabinet and vending machines.

4
MR15 User’s Manual V1.0
1.2 Interface
Pic.1-1
Power
Button
SCAN
Button
HDMI
USB 2.0
RJ45
RS232
GPIO
USB-C
Antenna Port

5
MR15 User’s Manual V1.0
1.3 Accessory List
1
MR15 reader, 12V power adaptor
2
UHF antenna, 6dBi, 9dBi, 12dBi etc.
3
Feeder line, SMA male side connects with device, interface
on other side needs match with antenna.
4
RJ45 Ethernet cable
5
HDMI cable
6
4G external antenna
7
WIFI external antenna

6
MR15 User’s Manual V1.0
1.4 Device installation
MR15 reader adopts Android operating system, it can be
connectedwith Internet through RJ45, WIFI and 4G etc. And
connect with monitor through HDMI cable.
Developer could use USB cable to connect device with PC for
developing application, device could also be connected with PC
through serial port cable.
Pic.3-1

7
MR15 User’s Manual V1.0
Chapter 2 UHF demo
2.1 Operating Interface
Pic.4-1

8
MR15 User’s Manual V1.0
Connect monitor through HDMI cable and long-press power button
for 3 seconds to switch on device. Click demo_uhf icon to enter demo
as Pic.4-1, UHF module will initiate as Pic.4-2, if there is no error
messages show up, then initiation process has been successfully
finished. “init. fail” means UHF module failed to initiate, need to exit
application and repeat operation. If initiation cannot successfully
finished, need to contact tech support for further.
Pic.4-2

9
MR15 User’s Manual V1.0
Chapter 3 UHF tag scanning
Click SCAN on top of navigation bar to enter tags reading page.
3.1 Auto Scanning
Select “Auto”, then click “Start” button to start tags scanning
circularly, the information such as EPC or TID, Count, RSSI and Ant.
number. As Pic.5-1.
“filter” button can be used to setup tag which has been filtered, user
could setup address, data length to filter tags. EPC, TID and USER
areas can be selected, setup data length to 0 and clear EPC list, then
click “Setup” to confirm in Pic.5-2.
Pic.5-1

10
MR15 User’s Manual V1.0
Pic.5-2

11
MR15 User’s Manual V1.0
3.2 Single Scanning
Select “Single” button and click “Start” to start scanning tag, EPC or
TID, Count, RSSI and Ant.number will display on right side, as Pic.5-
3.
Pic.5-3

12
MR15 User’s Manual V1.0
3.3 Read UHF Tag
Click “READ” on top of navigation bar to enter page of tag reading.
User could read data of 4 areas, RESERVED, EPC, TID and USER,
setup address and data length, default password is “00000000”, click
“Read” to read tags in Pic.6-1.
Pic.6-1

13
MR15 User’s Manual V1.0
Comment: user could filter tags by setup address, data length and
data in EPC, TID and USER areas, select “Enable” button to switch
on filter function in Pic.6-2.
Pic.6-2

14
MR15 User’s Manual V1.0
3.4 Write Tag
Click “WRITE” on top of navigation bar to enter tag writing page.
User could write data in RESERVED, EPC, TID and USER areas,
setup start address and data length, input access password and
data(hex), click “Write Data” to write data in Pic.7-1.
Comment: user could filter tags by setup address, data length and
data in EPC, TID and USER areas, select “Enable” button to switch
on filter function.
Pic.7-1

15
MR15 User’s Manual V1.0
3.5 Lock Tag
Click “LOCK” on top of navigation bar to enter tag locking page.
Input access password( DONOT input default password.), then click
column of “Lock Code”, it will display window for selecting different
methods of locking, click “OK” to generate lock code automatically,
then click “Lock” to lock tags in Pic.8-1 and Pic.8-2.
Comment: user could filter tags by setup address, data length and
data in EPC, TID and USER areas, select “Enable” button to switch
on filter function.
NOTE: If permanent mask has been locked, then it cannot be
unlocked. Vice versa.
Pic. 8-1

16
MR15 User’s Manual V1.0
Pic.8-2

17
MR15 User’s Manual V1.0
3.6 Kill Tag
Click “KILL” on top of navigation bar to enter operating page.
Input access password (DONOT input default password.), click “Kill”
button to destroy tags in Pic.9-1.
Comment: user could filter tag by setup address, data length and
data for selecting EPC, TID or USER area.
Pic.9-1

18
MR15 User’s Manual V1.0
3.7 UHF Module Version
Click 3 dots on top right of application and click “About” in list to
check version of UHF module in Pic.10-1.
Pic.10-1

19
MR15 User’s Manual V1.0
3.8 Module Temperature
Click 3 dots on top right of application, click “Module temperature” in
list to check UHF module temperature in Pic.11-1.
Pic.11-1

20
MR15 User’s Manual V1.0
Chapter 4 Config
Click “CONFIG” on top of navigation bar to enter setup page.
4.1 Working mode
User could setup different frequency band for different countries, as
Pic.12-1, click “Set Frequency” to confirm frequency band. Click “Get
Frequency” to check current frequency band.
Pic.12-1