Martha Stewart E&E - SAN PEDRO ACCENT CHAIR User manual

Page 1 of 2
Description QTY
Parts List
Item
P1
P2
P3
Step 1. Assemble the chair on a flat, soft surface such as a carpet or cloth to prevent scratching the finish.
Hardware List
QTY
Description
Item
Pre-assembly:
Take out all parts and hardware from box.
Do not discard any content until assembly is complete to avoid accidentally discarding small parts or hardware.
Important safety instructions:
Please read carefully all instructions before assembly.
For your safety and ease, assembly by two or more adults is recommended.
Keep instructions for future use.
ASSEMBLY INSTRUCTIONS
Description: E&E - SAN PEDRO ACCENT CHAIR
Assembly Procedures:
REST + SEAT
+ CUSHION 1
FRONT LEGS
LEFT&RIGHT 2
BACK LEGS 2
H1
H2
H3
H4
H5
H6
ALLEN KEY 4 MM
BOLT M6 X 50 MM
BOLT M6 X 30 MM
SPRING WASHER 6 X 11 X 2
WOODEN PLUG
FLAT WASHER 6 X 16 X 2
1
8
4
12
12
4
Legs and
hardware
package

Page 2 of 2
Thank you for your purchase
ADDITIONAL NOTE ABOUT SAFETY: BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE. THEY SHOULD BE
PERIODICALLY INSPECTED AND RE-TIGHTENED TO PREVENT DAMAGE OR INJURY. ALWAYS CHECK TO ENSURE THAT ALL
HARDWARE IS KEPT TIGHTENED.
P1
P3
P3
H1
H2
H4
H5
H2
H4
H5
P2 P2
H1
H3
H4
H5
H6
H3
H4
H5
H6
(H1) x 1
(H2) x 8
(H3) x 4
(H4) x 12
(H5) x 12
(H6) x 4
ALLEN KEY 4 MM
BOLT M6 X 50 MM
BOLT M6 X 30 MM
SPRING WASHER 6 X 11 X 2
WOODEN PLUG
FLAT WASHER 6 X 16 X 2
ASSEMBLY INSTRUCTIONS
Description: E&E - SAN PEDRO ACCENT CHAIR
Step 2: Attach back legs (P3) to chair top (P1) using Lock washers (H1), Spring washer (H4), Flat washers (H5)
and 50 MM Bolt (H2),next attach the front legs (P2) using Lock washers (H1), Spring washer (H4), Flat washers
(H5), 50 MM Bolt (H2), and 30 MM Bolt (H3), then cover the hole with wood plug (H6) as shown below.
Step 3: Turn the assembled chair to an upright position. Assembly is complete.