Martha Stewart Irisa User manual

Page 1 of 2
Description QTY
Parts List
Item
P1
P2
Hardware List
QTY
Description
Item
H1
H2
H3
H4
ASSEMBLY INSTRUCTIONS
Description: Irisa Accent Table
Step 1: Assemble the table on a flat, soft surface such as a carpet or cloth to prevent scratching the finish.
Attach Metal Legs (P3) to Table Top (P1) as shown below:
Assembly Procedures:
Pre-assembly:
Take out all parts and hardware from box.
Do not discard any content until assembly is complete to avoid accidentally discarding small parts or hardware.
Important safety instructions:
Please read carefully all instructions before assembly.
For your safety and ease, assembly by two or more adults is recommended.
Keep instructions for future use.
DISCLAIMER:
WHEN PROPERLY ASSEMBLED, THIS ITEM IS SAFE FOR INTENDED USE. SELLER IS NOT LIABLE FOR ANY DAMAGES
RESULTING FROM ITEM BEING IMPROPERLY ASSEMBLED AFTER PURCHASE.
1
Bolt Ø1/4" x 5/8"
FlatWashers Ø1/4"
Lock Washers Ø1/4"
(H1)x4
(H4)x4
(H5)x1 Flat Washers Ø1/4"
Alen Wrench
Bolts Ø1/4" x 5/8"
P3 Metal Legs
Metal Base
Table Top
1
4
H5
H1
H3
H4
(H3)x4 Lock Washers Ø1/4"
H5 Alen Wrench
Bolt Ø1/4" x 1 1/4" 4
4
8
8
1
P3
P1

Page 2 of 2
Thank you for your purchase
ADDITIONAL NOTE ABOUT SAFETY:
BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE.
THEY SHOULD BE INSPECTED AT LEAST EVERY 3 MONTHS AND RE-TIGHTENED AS NEEDED TO PREVENT DAMAGE OR
INJURY, AND ENSURE STABILITY.
a. Securely tighten all bolts with Allen wrench (H5), turn the assembled table to an upright position.
b. Assembly is complete.
c.Failure to follow these instructions may cause the bolts to misalign during assembly.
Step 2: Attach the Metal Base (P2) to the assembled Metal Legs (P3) as shown below.
(H2)x4
(H3)x4
(H4)x4 Lock Washers Ø1/4"
Flat Washers Ø1/4"
Bolts Ø1/4" x 1 1/4"
Step 3:
H4
H2
H5
H3
(H5)x1 Alen Wrench
P3
P1
P2
Leveler
Note: Legs can be adjusted
with adjustable levelers.