INSTRUCTIONS
- Always make sure that your hair is completely clean and dry before using curling iron.
- Make sure there is no water on the oor or on other surfaces near the outlet or the curling iron.
- Insert the plug of the curling iron into the outlet. The curling iron could have a polarized plug, which has one
pen which is wider than the other. If this is the case, this plug will only t into an outlet when it is placed
correctly. When the plug does not t into an outlet, make sure that you have the large pin stabbed into the
correct hole. If you cannot plug in the plug without any problems, please contact an electrician; never try to
force stabbing the plug into an electrical outlet.
- Press the “ON/OFF” button on the top of the curling iron until the temperature is shown on the display. The
hair styling tool will instantly warm up, but it will take about 40 seconds before it has optimal uniform heat
distribution.
- When the curling iron is at temperature, you can set the desired temperature with the +/- button at the top of
the hair styling tool. The most used temperature is 180 degrees, but this depends on the type of the hair.
Put on the included heat-resistant gloves. Avoid each contact between bar and skin when the hair styling tool
is in the “ON” position. The bar is hot and can cause burns. Furthermore, be sure to pay attention to your
ears while turning or moving of the curling iron because your scalp and hands are not the only thing that you
can burn.
- Divide the hair and start with long hair with the lower locks at the bottom of your head. You can place the cur
ling iron at the start of a lock and place it around the curling iron (a guideline in every technique is that when
you turn inwards, you create more curls. And when you turn out, you create more volume.) Make sure that
the hair lies at on the bar. After this, wrap the rest of the lock around the rod. In this way the hair is
well divided, the warmth is divided evenly through your hair and each part of the lock forms into the right
shape. After 3 seconds of warming, let the lock fall into your palm and let it cool down for 3 seconds before
you release it. The cooling down is a very important step for longevity of the curls. Always start at the bottom
and then grab a lock that is higher. The closer your curling iron is to your roots, the more curls you get in your
hair. If you want a full bunch of curls or waves, start with the curling iron close to the roots of your hair. Howe
ver, always be careful not to burn your scalp. If you just want to have curls at shoulder height, turn the curling
iron from the middle of the hair lengths.
- Finished? Press the ‘ON/OFF’ button until the temperature is no longer shown on the display. Unplug the
power cord and let the hair styling tool cool down completely on a heat-resistant surface before storing it.
Never leave the styling tool in the outlet or turned on if you are not around.
SAFETY INSTRUCTIONS
- Always unplug the appliance immediately after using.
- Do not use while bathing.
- Do not place or store appliance where it can fall or be pulled into a tub or sink.
- Do not drop into water or other liquids.
- If the appliance falls into water, unplug immediately. Do not reach into the water.
- This appliance should never be left unattended when plugged in.
- Close supervision if necessary when this appliance is used by, on, or near children or individual with certain
disabilities.
- Use this appliance only for its intended use as described in the manual. Do not use any attachment not
provided by the manufacturer.
- Keep the cord away from the heated surface.
- Do not warp the cord around the appliance.
- Do not use outdoors or operate where aerosol products are being used or where oxygen is being
administered.
- Do not use an extension cord with this appliance.
- Do not place the heated appliance directly on any surface while its hot or plugged in.
