Maxi Climber XL Operating and safety instructions

PART #33 REPLACEMENT MANUAL
STEP 1
Remove the knobs (25) that
secure the pistons (34), then
remove the pistons (34) from
the adjusting tubes (9 and 10)
and place them on the cylinder
bracket (45), then secure
pistons with knobs (25).
STEP 2
Remove the upper
handlebars (11) by removing
the knob (49).

STEP 3
Take off the steel rope (26)
from the adjusting tubes (9
and 10).
STEP 4
Take away the curved
stabilizer (1) by removing
the screws, nuts and
washers (17, 18 and 72).

STEP 5
Remove the screws, nuts,
washers and cushions from
the bottom of the machine
(19, 20 and 21).
STEP 6
Take off the connecting
sheet of rear stabilizer (4)
and the U bracket will come
out too (3).

STEP 7
Slide the adjusting tubes (9
and 10) towards the bottom
of the machine until they
come out completely.
STEP 8 (4 pulley version)
From adjusting tubes (9 and
10) remove the screws (32).
Take off the pulleys (33) so
you can replace them for
new ones.

STEP 8 (5 pulley version)
From adjusting tubes (9 and
10) remove the screws (32).
Take off the pulleys (33) so
you can replace them for
new ones. Then remove
cross head bolt (66) and the
flat head bolt (77) to
remove plastic roller (76)
and replace them for new
ones.
For reassembly repeat steps 1 to 7 in reverse order.