Maximum HG3200 User manual

High Volume Ultraviolet Hydroxyl Machine
Model HG3200 & HG6400
User Guide
"Knock outodors at their source"
Please read all of the infromation provided in this user's guide
before operating your new air unit.

Warning!
This air unit is not a medical device. Do not stop or alter any medical
therapy programs or medications without the advice of your
physician.
CAUTION
RISK OF ELECTRICAL
SHOCK DO NOT OPEN
ATTENTION
CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO NOT
REMOVE COVER. NO USER SERVICEABLE PARTS INSIDE. REFERING
SERVICING TO QUALIFIED SERVICE PERSONNEL.
This "bolt of lightning" indicates that uninsulated material within your unit may cause an electrical
shock. For the safety of everyone, do not remove product covering.
This "explamation point" calls attention to a feature for which you should read the enclosed literature
carefullly to prevent operating and maintaenance problems
Read ALL instructions carefully before using this product.
For Your Records

Please record the model and serial number below, for easy reference, in case of loss or theft.
These numbers are located on the back panel of your air purification unit. Space is also
provided for other relevant information.
Model Number__________________________________________________________
Serial Number___________________________________________________________
Date of Purchase_________________________________________________________
Purchased From__________________________________________________________
Operating the HG3200
(Front View)

Two Speed: 2200 rpm or 3300 rpm, Simply flip switch on handle. May
be used in occupied settings. Never aim the unit directly at people or
pets.
GFIC Protected: Always push the reset button after pluging the
machine. Never use the unit with an extension cord!!!
UV Light: Generates hydroxyl ions. kill bacteria, mold germs, etc.
Light is rated for 8000 hours of use.
(Back View)

Never use with an extension cord. Will void warranty!
Built in circut breaker on plug end.
Power Cord: 110 volt grounded cord. DO NOT BYPASS GROUND!
This unit must be provided with an electrical ground at all times!

Operation
The HG3200 and HG 6400Odor Remover is designed to remove odors and clean the air in both
occupied and unoccupied spaces by using UV Hydroxyl Ions. Run the unit for as long as
needed to remove odor. Simply run the unit until all odors are gone and then shut the Industrial
Cleaner off.
Never run the system unattended in the presence of children.
To operate the Ultraviolet Air Sanitizer:
•Close off the desired area to be treated.
•System works better with high humidty.
•System may be run in occupied areas in normal mode.
•Position the unit as close as possible to the odor source.
•In such enviroments as motels that have individual heating and cooling systems, turn
the fan on and set on re-circulate.
The amount of time necessary to eliminate pollutants depends on the type of pollutant causing
the odors.
Hydroxyl Ion: Works better for areas of higher humidity.

In order to treat a specified area, the air in that area does not need to pass through the unit as
with air filtration devices. Instead, the unit generates hydroxyl ions internally which circulates
throughout tlhe room to attack odors at the source.
It will control odors from sources such as:
Cigarette Smoke, Cooking Odors, Water Damage, Mold & Mildew, Decaying Matter, Cleaning
Fires and Smoke Damage, Pet Odors, New Construction, Paint Fumes, Carpet Odors, Pesticides.
The Industrial Cleanier is ideal for such applications as:
Automobiles, Airplanes, Carpet Cleaning, Boats, Offfice Buildings, Property Management,
Basements, Food Markets, Motel / Hotel Resorts, Limousines, Food Service, Recreational
Vehicles and any commercial or professional use.
Warning: Even though the light is UVA, do not stare at it for prolonged periods may result from
directly viewing the light produced from the UV lamp used in this product. Always unplug unit
when not in use.
Never Use With An Extension Cord!
Troubleshooting
If you suspect a problem with your unit check the following:
•Unit is plugged in properly grounded outlet and turned on.
•Wall outlet is active.
•Reset breaker on end of cord.
If fan is still not operating, no buzzing sound is detedted or UV light is not working when unit is
turned on, please contact your Maximum Air dealer. Do not disassemble unit.
Caution: No attempt should be made to open the unit, as there are no user serviceable parts.

Opening the unit without consent may void warranty.
[email protected]
Sani-Clean Maximum Air Purifier 3 Year Warranty Card
1 Year Warranty
Customer Name______________________Model Number_________________
Address____________________________Serial Number________________
Email Address______________________Date Purchased_______________
Dealer Name_____________________City_______________State________
Warrantor, Sani-Clean, warrants to the original purchaser of this air purifier unit
that should it prove to be defective by reason of improper materials or workmanship
(a) For 1 year from the original owner purchase date, the warrantor will repair
any defective part without charge for the parts or labor. The owner will be responsible
for shipping both directions. Warranty Restrictions (a) Trying to repair the unit
without authorization from the Warrantor or Service Dealer will void the warranty.
(b)This warranty is invalid if the factory applied serial number has been altered
or removed from the product. (c)This warranty does not cover cosmetic damage or
damage due to acts of God, accident, misuse, abuse, begligence, or modification
of or to an;y part of this product. (d)This warranty does not cover damage to to
improper operation or maintenance, connection to improper voltage supply, or
unauthorized attempted repair by anyone other than a facility authorized by Sani-Clean.
Warranty Service: To obtain warranty service, the consumer must (a)Contact the
Authourized Dealer they purchased it from or an authorized Sani-Clean Service Center.

Sani-Clean only accepts warranty work from its Authorized Dealers. (b)Provide proof
of purchase in the form of a Bill of Sale or receipted invoice: include copy of
the warranty. (c)Ship the unit freight prepaid, in either its original packaging
or packaging affording an equal degree of protection, to the authouized dealer they
purchased it from or an authorized Sani-Clean Service Center. Payment for return
shipping costs must be incluced as well.
All transportation charges and shipping expenses (to AND from warranty center) are
the purchaser's responsibility. Shipping insurance should be purchased if unit is
shipped. Sani-Clean Warranty Center or Service Dealer will return the unit by ground
shipping.
A unit returned for repairs that damage for which Sani-Clean is not responsible
or does not cover, will be repaired for a reasonable charge as determined by
Sani-Clean's authorized dealer or service center. Before service is rendered for
non warranty cases in that issue the customer will be notified of reasonable charge
amount before work is performed. There will be 3 attemps made to advise purchaser
of the cost of replacement before proceeding. If no contact, reply or no return
information is provided Sani-Clean or its representatives may dispose of the unit
and not be responsible for the unit if the customer has not paid or contacted Sani-Clean
or its representative.