MAXLOAD 93742 User manual

93742
ROOFTOP RACK WITH AWNING
User Manual
WARNING AND SAFETY INFORMATION
• DO NOT ATTEMPT TO SET UP AWNING IN WINDY CONDITIONS.
• ALL GUY ROPES MUST BE ATTACHED AND PEGGED TO THE GROUND AT
ALL TIMES.
• GUY ROPES ARE TRIP HAZARDS IN THE DAY AND NIGHT.
• KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THE AWNING.
• UNDER NO CIRCUMSTANCE SHOULD ANY NAKED FLAME SOURCES OR
HEATING DEVICES BE USED UNDER OR NEAR THE AWNING.
• LOOK OUT FOR ANY AIRBORNE BURNING EMBERS THAT MAY COME INTO
CONTACT WITH THE AWNING.
• DO NOT OPERATE ANY DEVICE WHICH BURNS FUEL INSIDE OF THE AWNING.
KEEP EXIT CLEAR DURING TRIPS.
• REGULARLY CHECK THAT ALL NUTS AND BOLTS ARE ATTACHING TO YOUR
VEHICLE TIGHTLY AND IN GOOD CONDITION.

2
INSTALLATION
Option 2
Installed on Cross bars
Option 1
Installed on Roof racks
Slide the small bolts into the mounting rail of the awning, raise the awning and Align awning
into the position of the shorter part of the L bracket, screw together with supplied bolts.
Check all nuts and bolts periodically.
Attention:
1. Put a soft cloth or cushion above the mounting area to avoid any potential damage to
your car during installation.
2. Use hardware as per different car models. Install L brackets on the rails, roof rack or cross
bars. (Hardware is more than required, just in case of installation on wider car models.)

3
SET UP INSTRUCTIONS

4
1. Undo the zip on the PVC bag, and release the buckles which hold the awning in place.
2. Unfold the awning to its full length.
3. Release the legs of awning to desired height and tighten the locator.
4. Release the rafter arms of the awning and insert it into mounting holes and tighten
the locator.
5. Secure the fabric to the rafter arms using the Velcro tabs.
6. Peg the legs to the ground using the rope loops in the feet, and guy rope to secure in
case of winds.
4pc L Bracket
8pc Long bracket clamps
2pc Pegs
2pc Short bracket clamps 2pc Spanners
8pc Long bolts 8pc Short bolts
SET UP INSTRUCTIONS
2pc Guy Ropes1pc Storage Bag