Mayline Cohere 1842 User manual

ASSEMBLY INSTRUCTIONS
COHERE FLIP & NEST TABLE
1. Place Top (1) face down on a clean flat surface. Attach Mech/Handle Assembly (2) onto Top
using 12 Screws (E1). **
COMPONENTS
REF# QTY. DESCRIPTION PART NO.
1 1 Top CALL ~~**
2 1 Mech/Handle Assy CALL~~
3 1 Leg Assembly CALL ~~**
HARDWARE BAG (Part No. DS111)
REF# QTY. DESCRIPTION
E1 20 Screw, #12 x 1" PHS
E2 8 Screw, 1/4-20 x 1/2" PHS
E3 6 Cable Clip & Screw, #6 x 1/2" PHS
Replacement Parts not included in assembly
REF# QTY. DESCRIPTION PART NO.
R1 1 Caster Standard DS108
R2 1 Caster Premium DS109
R3 1 Pull Handle, Yoke DS469
NOTE:
PLEASE COUNT AND INSPECT ALL PIECES BEFORE DISPOSING OF ANY CARTON OR PACKING MATERIALS.
** Denotes Color Code
~~Denotes Size
When ordering components, specific color and/or size information may be required.
Contact a Mayline Customer Service Representative. 1-800-822-8037
**IMPORTANT**
PLACE MECH ASSY WITH CABLES
OPPOSITE SIDE OF HANDLE.
(1)
P/N REV 02 09/08/15
Recommended tools for Assembly:
#3 Phillips bit for larger screws.
#2 Phillips bit for smaller screws.

2. Rotate the handle assembly to unlock, then
rotate the Mech assembly up 90 degrees. Attach
additional 8 Screws (E1) into the Top.
3. Attach Leg Assembly (3) onto the Mech Assembly using 8 Screws (E2).
4. Layout cable on one side similar as shown below and attach 2 or 3 Cable Clips (E3) to
Top using Screw (E3). **For the best appearance mirror Cable Clips & Screws on other
side.**
Underside View
(2)

OPERATING INSTRUCTIONS
1. Rotate Top Up - Rotate handle to unlock and lift table top up 90 degrees.
2. Rotate Top Down - Rotate handle to unlock and lower table top down 90 degrees.
(3)
Extra inserts on the underside of the top are for optional ganging kit 10GA & Pie connectors.
10GA Ganging Kit 30°
Pie Connector
45°
Pie Connector
90°
Pie Connector
Replacement Parts not included in assembly