Install the inlet male connector,
connect garden hose and inlet
connector, and turn the water on.
Makes sure the ON/OFF switch is
in the OFF position.
Insert the spray lance into spray gun,
and twist 1/4 turn to lock in position.
Check that it is rmly securely located
in place.
Unlock the safety trigger on the
spray gun and press the trigger to
pull the water through the machine,
until a steady stream of water runs
from the lance.
Turn the nozzle to the desired
spray width and pull the trigger on
the spray gun to release a
pressured water spray.
Pls turn o the machine when you
want to change the lance.
Power on the pressure washer.
Special pressure washer
detergents can be used to increase
the cleaning power of the pressure
washer.
Connect garden hose (non-supplied)
and water supply. Let the water run
through the hose and turn it o.
1. ASSEMBLE 2. PREPARE 3. OPERATE
1 2
3 4
56
7 8 11 12
13 14
15 16
9 10
