PERFORMANCE SPECIFICATIONS
2
1. The heavy notes on the schematic denote the primary
signal path.
2. Unless otherwise noted, all voltages indicated on the
schematics are measured under the following conditions:
a. ACinputat120volts,50/60Hz.
b. All voltages are +/-10% with respect to ground. A
high impedance (10 megaohm) voltmeter must be used.
3. Unless otherwise specified:
a. Resistor values are in ohms.
b. Capacitorvalues aremicrofarads (uF).
c. Inductor values are in microhenries (uH).
4. On PC board drawings, Square pad indicates:
a. PolarizedCapacitors-Positive
b. Diodes - Cathode
c. Others - Pin 1
5. WARNING
Parts marked with the symbol have critical
characteristics. Use only replacement parts recom
mended by the manufacturer.
6. Use McIntosh Remote Control Model HR052 with the
MVP861.
NOTES
GeneralSpecifications
PowerRequirements
100Volts,50/60Hzat120 watts
110Volts,50/60Hzat120 watts
120Volts,50/60Hzat120 watts
220Volts,50/60Hzat120 watts
230Volts,50/60Hzat120 watts
240Volts,50/60Hzat120 watts
Note: Refer to the rear panel of the C1000 Controller for the
correct voltage.
OverallDimensions
C1000C:
Widthis17-1/2inches (44.45cm)
Height is 6 inches (15.24cm) including feet
Depth is 24 inches (61.0cm) including the Front Panel, Knobs and
Interconnect Cables1
C1000P:
Widthis17-1/2inches (44.45cm)
Height is 6 inches (15.24cm) including feet
Depth is 24 inches (61.0cm) including the Front Panel and
Interconnect Cables1
C1000T:
Widthis17-1/2inches (44.45cm)
Height is 6 inches (15.24cm) including feet
Depth is 24 inches (61.0cm) including the Front Panel
and Interconnect Cables1
Weight
C1000C-39.0pounds (17.7 kg)net
61.4 pounds (27.9 kg) in shipping carton
C1000P-33.0pounds (15.0 kg) net
53.6 pounds (24.3 kg) in shipping carton
C1000T-34.0pounds(15.4 kg) net
54.6 pounds (24.8 kg) in shipping carton
1Interconnect Cables are supplied with the C1000
PreamplifierandC1000Tube Preamplifier.They are used
toconnectPreamplifier(s)totheC1000Controller.
