MD SPORTS TP200Y23004 User manual

www.medalsports.com877-472-4296
Assembly Instructions
MODEL
TP200Y23004

This product is covered by a limited warranty that is effective for 90 days from the date of purchase. If, during the limited
warranty period, a part is found to be defective or breaks, we will offer replacement parts at no cost to you, the customer.
The only exceptions to the warranty include mainframes, table tops, playing surfaces, batteries or tools.
The above warranty will not apply in cases of damages due to improper usage, alteration, misuse, abuse, accidental
damage or neglect.
This Limited Warranty gives you specific legal rights and you may also have other rights vary from one State (province) to
another.
A PURCHASE RECEIPT (or other proof of purchase) will be required before any warranty service is initiated. For all
requests for warranty service, please feel free to contact our Consumer Service Department.
Please be aware of your product’s Limited Warranty for the return/refund policy from the store, We, at Medal Sports,
cannot handle the product which is out of product’s limited warranty since we only provide available parts. Thank you!
PLEASE CONTACT US BEFORE RETURNING THE PRODUCT TO THE STORE!
MD SPORTS
877-472-4296
www.medalsports.com
Customer Service Toll Free
Please Contact
Mon.-Fri., 9:00 a.m. to 5:00 p.m. EST
For additional resources and Frequently Asked Questions, please visit us at
DO NOT RETURN TO STORE
WE ARE READY TO HELP
TP200Y23004 1(Continued on the next page) www.medalsports.comTP200Y23004 1(Continued on the next page.) www.medalsports.com
English
LIMITED 90 DAYS WARRANTY

This product is intended for INDOOR use only.
Wipe with a clean cloth wrung in water or in a solution of water and a neutral detergent.
Adult supervision is required for children playing this game.
1.
2.
3.
- Not Included
- Not Included
- Included
RECOMMENDED
IMPORTANT NOTICE
Adult assembly required.
CHOKING HAZARD - This item contains small parts and small balls. Not suitable for children under 3 years.
WARNING
Phillips Screwdriver
Standard (Flat Head Screwdriver)
Allen Key
Electric Screwdrivers may be helpful during assembly; however, please set a low
torque and use extreme caution.
Power Tools: Set to Low Torque
High Torque Over Tightened
TP200Y22010 2(Continued on the next page) www.medalsports.com
Do not use or keep
product outdoors. For
indoor use only. No
wet/humid conditions.
Keep away from pets in
assembly area
No children in assembly
area
TP200Y23004 2(Continued on the next page.) www.medalsports.com
English
TOOLS REQUIRED

FOR FIG. 6
7
x2
Slide Scorer
8
x8
FOR FIG. 3 9
x1
FOR FIG. 2
Rod Bumper
ACCESSORIES
HARDWARE
PART NUMBER FIG. NUMBER
QUANTITY
PART
PART NAME Side Apron-A
1
x1
FOR FIG. 1
11
x2
Soccer Ball
FOR FIG. 3
6
x2
3 - Player Rod - Red
FOR FIG. 2
A2
x2
A1
x8
FOR FIG. 1, 4
M4x20mm Bolt
A3
x4
A4
x1
Allen Key
M2.6x6mm Screw M2.6x8mm Screw
Battery Box
10
x4
FOR FIG. 5
Handle
FOR FIG. 2
4
x1
Playfield
3
x2
FOR FIG. 1
End Apron
5
x2
FOR FIG. 3
3 - Player Rod - Blue
2
x1
FOR FIG. 4
Side Apron-B
FOR FIG. 5
TP200Y23004 3(Continued on the next page.) www.medalsports.com
English
PARTS IDENTIFIER

Note: Do NOT tighten
bolt (A1) until FIG. 4.
1
1
x4
x1
P1
P1
x2
3
3
x4
A1
x1
A4
Pre-installed
FIG. 1
P5
x4
FOR FIG. 3
3 - Hole Rod
FOR FIG. 3
P6
x4
Rod End Cap
ASSEMBLY
BEFORE ASSEMBLY
Find a clean, level place to begin the assembly of your product.
Verify that you have all listed parts as shown on the part list pages. If any parts are missing, call our customer service.
1.
2.
FOR FIG. 3
P2
x6
Player - Blue
P1
x8
FOR FIG. 1, 4
Rod Bushing
FOR FIG. 3
P4
x12
M2.5x8mm Screw
P3
x6
FOR FIG. 3
Player - Red
A1
TP200Y23004 4(Continued on the next page.) www.medalsports.com
English
PRE-INSTALLED PARTS

x2
A2
x1
A4
4x1
9x1
Grooves
FIG. 2
Battery Box
4
9
BA2
A
TP200Y23004 5(Continued on the next page.) www.medalsports.com
English
ASSEMBLY

FIG. 3
5
x6
x2
P2
x12
P4
x4
P5
x2
6
P3 x6
x8
8
Pre-installed
Pre-installed
Pre-installed
x4
P6
Pre-installed
Pre-installed
FIG. 4
2
x4
x1
x4
A1
P1
Pre-installed
x1
A4
Note: After this step,
tighten the bolts (A1).
P1
2
A1
A1
8
5
6
The Hole
P3P2 &
P5
P4
The Hole
P6 8
TP200Y23004 6(Continued on the next page.) www.medalsports.com
English
ASSEMBLY

FIG. 5
10 x4
FIG. 6
7x2
7
The Hole
10
x1
A4
A3 x4
A3
TP200Y23004 7(Continued on the next page.) www.medalsports.com
English
ASSEMBLY

Requires 2 pcs 1.5V “AA” batteries (not included).
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc.) batteries.
1.
2.
3.
WARNING
The batteries must be installed according to their correct polarization (+ and -).
Please clean the battery contacts and also those of the device prior to battery installation.
If the game will not be used for a long period of time, we recommend removing the batteries.
a.
b.
c.
REMINDING
Battery Box: Unscrew the bolt using a screwdriver and open the battery box. Insert 2 pcs 1.5V “AA” batteries (not included)
in the sequence of polarity as shown on the inside cover. Then close the cover using a screwdriver.
Turn the power ON using the ON/OFF switch.
“ON/OFF” SWITCH
TIP
Plip the “ON/OFF” switch to turn the led lights on.
(BOTTOM OF TABLE)
Battery Box
Led
Led
BATTERY INSTALLATION
TP200Y23004 8(Continued on the next page.) www.medalsports.com
English
ELECTRONIC CONNECTIONS DIAGRAM

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
WARNING
TP200Y23004 9(The last page) www.medalsports.com
English
DISCLAIMER