Assembly Instruction
Driving cap floor assembly kit for
TAMIYA Arocs 3363 (1:1 )
- dividing wall + seat holder -
Best.-Nr.: 2017-9006-06
Version 1.0 – 05.07.2017
MDTechShop – Torfstrasse 7 – 71229 Leonberg - Email: team@m techshop. e - 1/3
Beschreibung
This kit inclu es parts for a riving cab floor for the
TAMIYA Arocs 3363 (M 1:14).
The cab floor will be mountet un er the original river seat hol er to hi e the
view onto the RC equipment through the win shiel .
For use of a speaker in the cabine roof you shoul cut a piece of sheet out off
the evi ing wall at will.
The original platform above the electric motor shoul be remove .
Assembly Procedure
Before you put the parts together please rea the assembly instructions
carefully an pay attention to the assembly sequence an test the fitting
accuracy of the parts before gluing them together.
The parts are ma e of polystyrene, if you use super-glue in combination with
activator spray, please be aware that the activator spray can estroy
polystyrene – because of that you shoul use it very carefully or use only
polystyrene-glue.
It is helpful to fix the parts at first only on a few points with super-glue an
after a check along the e ges fully with super-glue or a polystyrene-glue.
MDTechShop – Torfstrasse 7 – 71229 Leonberg - Email: team@m techshop. e - 2/3
