
Thank you for purchasing your MEC pickup. If you don‘t have
experience with wiring or soldering or if you are unsure how
to proceed with the installation, we strongly recommend that
you have the pickup installation performed by a specialist.
INSTALLATION / MOUNTING
1. Remove the strings from your instrument, open the
electronics compartment.
2. Carefully remove the old pickups. If necessary, take notes
about the solder joints. If you remove the old pickups
carefully and cleanly, the new pickups are easier to install.
3. Verify that the used electronics and parts are compatible
with your new pickups. When changing from passive to
active pickups, individual components must be replaced.
4. Use a thin-tip soldering iron and solder the wires from the
pickups into place. Mount the pickups.
5. Connect the red wires from all pickups to the red wire
from the battery clip.
6. Check the solder joints, isolate open cables, avoid short
circuits.
7. Close the electronics compartment and re-string your
instrument.