MedaCure CB650 User manual

Bariatric Commode
MedaCure Inc.
545 N. Arlington Avenue
East Orange, NJ 07017, USA
www.medacureinc.com
www.medacureinc.com
Medacure
Limited Warranty
© 2020 MedaCure Inc. All rights reserved.
MedaCure is a registered trademark of Medacure Inc.
East Orange, NJ 07017. Made in China.
The MedaCure Bariatric Commode is guaranteed to
be defect-free in materials and workmanship for one
(1) year from the date of purchase.
Damages that are not covered by this warranty
include defects due to misuse, abuse or negligence
and normal wear and tear on the device. This
warranty does not include or extend to non-durable
components, (i.e., rubber accessories, casters, and
grips), as they need periodic replacement due to
normal wear.
For questions about your MedaCure device and/
or the warranty, feel free to contact an authorized
MedaCure dealer.
Weight Capacity: 650 lbs.
Model # CB650

Assembly Instructions &
Safety Precautions
1. If exposed to the cold, allow toilet seat and lid to
come to room temperature before assembling to
prevent cracks from forming in the seat and lid
clamps during assembly.
2. Align the toilet seat clamps with the back frame
rail so that both clamps sit outside the pail
brackets. Apply pressure to the seat so that the
clamps snap into place rmly.
3. Repeat the step 2 for the lid.
4. Always remove lid before the seat. Grasp the
back of the seat and/or lid and lift to remove.
5. To install commode bucket, drop into bucket
frame. Reverse to remove.
Seat Clamps
Back Support
Bucket Frame
Back Frame Detail
Bucket Drops In
FIGURE #1
Adjusting Leg Height
1. Adjust height of legs to your specic needs before use,
ensuring that all legs are at set to the same height. Lock
legs into place by aligning buttons into proper holes
(see gure 2).
2. Push down on or pull on legs to be ensure legs are
locked into place.
FIGURE #2
Safety and Warnings
1. Toilet seat must be in down position before use
to avoid breakage of commode and possible
injury.
2. Please read and understand this assembly and
instruction sheet before installing commode.
Contact a healthcare professional, dealer or
technician before if you do not understand these
instructions before attempting to install to avoid
injury or damage.
3. Carefully review all parts for shipping damage
prior to assembly. Do not use if there has been
shipping damage. For further directions, contact
dealer/carrier.
4. Be sure that the height adjusting snap buttons
fully extend through the same respective hole of
each leg extension to secure the leg extensions
rmly position and a uniform height is set (see
Figure 1).
5. Ensure ALL screws, nuts and/or bolts are fully
tightened.
6. Inspect leg extension rubber tips for rips and
wear and make sure none are missing. If rips or
wear are found, immediately replace the tips.
7. Make sure all four leg extensions with rubber tips
continuously touch the oor simultaneously.
8. Supervise or assist users with limited physical
strength while using this product.
9. Arm supports should be used for assistance only.
Arms should not be used to support full body
weight.
10. Unlatch and drop arms to assist in user onto/off
of the commode.