Medcursor MD-FLM01 User manual
USER MANUAL
CALF & FOOT MASSAGER
IMPORTANT SAFETY INSTRUCTIONS
CARE AND STORAGE
PRODUCT INTRODUCTION
WARRANTY INFORMATION
DISCLAIMER
CUSTOMER SUPPORT
OPERATION INSTRUCTIONS
TROUBLESHOOTING
1-2
3-4
5-6
7-8
9
8
9
10
2
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED
WHEN USING ELECTRICAL DEVICES.
READ ALL SAFETY AND OPERATING INSTRUCTIONS BEFORE USING.
DO NOT stand on, or exert excessive pressure on the massager. This may significantly
slow down or stop the motor, potentially causing overheating or subsequent damage to
the massager.
The total recommended usage time of the massager is 15-30 minutes.
Some users may experience itchiness on their feet during and after the massage. This is
normal and a result of improved blood circulation.
This massager is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning the use of this
massager by a person responsible for their safety. Children should be supervised to
ensure that they do not play with the massager.
DO NOT use this massager in an excessively humid environment, such as the
bathroom.
DO NOT use this massager on a wet body, this may result in a short circuit or an
electric shock.
DO NOT place or store this massager where it may fall or be pulled into the water.
DO NOT place in, drop or soak the massager in water or other liquid.
DO NOT get for the massager when it fell into the water while plugged-in, disconnect
it first.
NEVER leave the massager unattended when plugged-in. Unplug it from the outlet
when not in use, and before putting on or taking off parts.
DO NOT place the massager near electric heaters, stoves or under direct sunlight.
DO NOT stand or sit on the massager itself.
DO NOT wash the massager directly with water or pour water into it. This may result
in electrocution, short circuit or possible fire.
DO NOT operate the massager with a damaged cord or tamper with the cord.
Contact customer service for maintenance and inspection in time.
DANGER
WARNING
11111 1 31 2
The following users must consult their doctor before use:
Please let the massager rest for 30 minutes after using it, and then perform the
second massage. Please control the daily massage time within 15-30 minutes, so
that the best massage effect can be obtained.
DO NOT overuse the massager on the same part of your body for a long time. The
excessive stimulation of the skin surface will make the part feel abnormally hot and
painful, which may cause inflammation or low-temperature burns.
DO NOT forcefully pull the foot sleeves. This massager should not be used without
the foot sleeves. Do not let the skin directly touch the massage heads to avoid skin
damage.
STOP using this massager if severe pain is felt during use.
If you detect any malfunction or any other irregularities during operation, switch the
power off immediately and contact customer support for repair.
People who are heat-sensitive should pay attention when the surface of the
massager becomes hot.
Turn off the power first if you need to move the massager, pull out the power plug,
and then move.
This massager contains a kneading massage device. It’s better to start at LOW
speed and adjust to high speed after the body adapts.
The massager must only be serviced or repaired by a recommended Medcursor
Customer Support.
Users must NOT disassemble or repair the massager themselves.
DO NOT insert or place any metallic objects or flammable materials into any opening.
DO NOT squeeze or scratch the massager with sharp objects.
DO NOT sleep while using the massager.
DO NOT use the massager if the electrical outlet is excessively loose.
ONLY use the adaptor and attachments supplied with this massager.
CAUTION
• Cancer patients
• People with osteoporosis
• Persons with malignant tumors
• People with high fever
• Pregnant women
11
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
3 4
PRODUCT INTRODUCTION
WHAT ARE INCLUDED
Wireless Remote User Manual
11111 3
You can operate directly on the control panel or using the wireless remote.
The indicator light is only displayed on the control panel of the massager.
REMOTE INSTRUCTIONS
TECHNICAL SPECIFICATIONS
1
Model No
18.8 x 16.9 x 11.22 inch
MD-FLM01
UNIT BODY
CONTROL PANEL
SHIATSU MASSAGE AREA
LARGE ANGLE ADJUSTABLE STAND
SMALL ANGLE ADJUSTABLE STAND
SUPPORT STAND
AIR PRESSURE AREA
GROOVE HANDLE
PLUG ADAPTOR OUTLET
AC 100V~240V 50/60Hz 12V 5A
12VDC
60W
Dimensions
Power Adapter
Rated Voltage
Rated Power
1
1
2
3
4
5
6
7
8
9
5
3
4
7
9
6
Calf & Foot Massager
8
9
AAA Battery*2 Press to switch auto turn off periods.
Green-15 mins
Red-30 mins
NOTE: Each function can be used separately.
Power Adapter
PRODUCT INTRODUCTION
PRODUCT INTRODUCTION
INTENSITY
Press to turn on / off the massager.
Press to switch / turn off air intensity.
Green-low intensity
(recommended to start with)
Yellow-medium intensity
Red-high intensity
Press to switch / turn off vibration.
Green-low intensity
Red-high intensity
The vibration is designed to
focus on your heel.
Press to switch / turn off the
shiatsu massage rolling speed.
Green: low speed
Red: high speed
Press to switch / turn off the
heating function.
Green-low temperature
Red-high temperature
2
Net Weight 11.9 lbs
Note: The schematic diagram is for reference only.
5 6
OPERATION INSTRUCTIONS
Remove the massager from the packaging and place it on a flat, level surface in
front of your chair.
Connect the adapter cable to the corresponding socket on the massager. Then
plug the adapter into an outlet.
The massager enters the standby state, the red indicator light of the ON/OFF
button flashes.
Press the ON/OFF button to activate the massager.
SETUP
OPERATION INSTRUCTIONS
OPERATION INSTRUCTIONS
NOTE: When the massager is activated with the ON/OFF button, it starts to work under
default mode:
VIBRATION HEAT AIR
INTENSITY ROLLING TIMER
EXAMPLES EXPLANATION
HOW THE TIMER CONTINUES TO
WORK AFTER SWITCHING
WHEN THE
MASSAGER
WORKED FOR
SWITCH/CHANGE
THE TIME
High
Temperature
Off Low
Intensity
Low
Speed 15 mins
78
CARE AND STORAGE
Be sure to remove the AC plug from the electrical outlet before cleaning the massager.
DO NOT store the massager near intense heat or an open flame.
DO NOT use benzene, thinner or any other abrasive solvent on your massager.
NEVER use a damp cloth to clean the massager or the power switch. Use a dry cloth
when cleaning the massager. Please use a soft small brush to clean the gap of the
massager.
Please remove the remote-control battery if you don’t use it for a long time.
When not in use for a long time, it is advisable that the AC power cord should be
coiled and the massager be stored in the original box or a dust and moisture free
location.
TROUBLESHOOTING
ISSUES CAUSES SOLUTIONS
ISSUES CAUSES SOLUTIONS
Fails to start
No vibration
Disconnected power or loose
connection of the adapter.
Reconnect the adapter and
re-plug to the power source.
Press the “ON/OFF” button to
activate.
Only use the adaptor and
attachments supplied with this
massager.
Connect to the power supply
or check whether the socket is
energized, you can try to
replace the socket.
The ON/OFF button is not turned
on.
Use the wrong adapter and
attachments.
The vibration function hasn’t
been activated.
Press the “VIBRATION” button
to activate this function
(indicator will light up).
No power.
Temperature
is too high
The heating
function does
not work
The adjustable
stand is unstable
Suddenly stop
working
Press the “HEAT” button to
adjust the temperature to low
heating (green light) or turn
off the heating function.
Adjust the stand to the maximum
angle and when you hear a
clicking sound, indicating that the
stand opening angle is in place.
Continuous using time is too
long. Overheating protection
activated and shut off the power
automatically.
Press the “Heat” button to
activate this function (solid
light).
This massager starts with a
heating function of high level in
default (red light).
It needs a few minutes to warm
up after activating the heating
function.
Activate heating function for a
long period.
Heating function hasn't been
activated.
The adjustable stand is not open
in place.
Press the “ON/OFF” button to
restart.
Massage time (15/30 mins) is
over.
Press the “ON/OFF” button to
restart the massager.
Cool the massager for 30-50
minutes, and restart the
massager.
Check the plug to ensure inserted
in place, check whether the
socket is powered.
Poor contact of the power
adapter.
Excessive force, causing the
massage heads blocked.
Let the massager cool down for
30 minutes or turn off the
heating function.
Please wait 3-5 minutes after
activating this function.
TROUBLESHOOTING
TROUBLESHOOTING
CARE AND STORAGE
Troubleshoot your problem by using the chart below. If the Calf & Foot Massager still does
not operate correctly, it may be defective. Please contact a qualified technician at
support @medcursor.com for a solution. DO NOT try to repair it by yourself. Otherwise,
there is a risk of electric shock.
9 10
WARRANTY INFORMATION
DISCLAIMER
CUSTOMER SUPPORT
Medcursor provides all of our customers with a warranty of 12 months from
the date of purchase. Please contact our customer service team at
support@medcursor.com if you have any questions.
Feel free to contact our Customer Support Team if you have any questions or
concerns regarding your foot massager. Your satisfaction is our priority.
Please include your Order ID in your email when you are contacting Customer
Support for faster solutions.
Medcursor assumes no liability for damages NOT resulting from defects in
material or workmanship, and malfunctions from other than normal use, including
but limited to, repair by unauthorized parties, tampering, modification, or
accident. Some countries or states do not allow this exclusion or limitation of
incidental or consequential losses so the foregoing disclaimer may not apply to
you.
IMPROPER USE OF ELECTRIC DEVICES INVOLVES SERIOUS
RISKS INCLUDING INJURY AND DISABILITY. YOU UNDERSTAND
THAT BY KEEPING, USING, OR ALLOWING THE USE OF
MEDCURSOR PRODUCTS, YOU AGREE TO THE FOLLOWING:
(2) USE LIMITATION. PLEASE DO NOT MODIFY AND REPRODUCE
MEDCURSOR PRODUCTS. PLEASE CAREFULLY INSPECT THIS CALF
& FOOT MASSAGER AND ENSURE IT HAS NOT BEEN DAMAGED
BEFORE EACH USE.
(1) MEDCURSOR IS NOT RESPONSIBLE FOR ANY INJURY WHICH
MIGHT OCCUR WHILE IMPROPERLY USING THIS CALF & FOOT
MASSAGER.
Order ID:
Date of Purchase:
WARRANTY INFORMATION DISCLAIMER
CUSTOMER SUPPORT
Table of contents
Other Medcursor Massager manuals
