Medical Depot Drive crawlabout CAB 2000 User manual

crawlabout
item # CAB 2000 & CAB 3000
www.drivemedical.com
two year limited
warranty
Your Drive brand product is warranted to be free of
defects in materials and workmanship for two years
from the date of the original consumer purchase.
This device was built to exacting standards and
carefully inspected prior to shipment. This Two
Year Limited Warranty is an expression of our
confidence in the materials and workmanship of
our products and our assurance to the consumer of
dependable service.
In the event of a defect covered by this warranty, we
will, at our option, repair or replace the device.
This warranty does not cover device failure due to
owner misuse or negligence, or normal wear and
tear. The warranty does not extend to non-durable
components such as rubber accessories, casters, and
grips, which are subject to normal wear and need
periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized
Drive dealer.
© 2006 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
A
CD
E
F
G
crawlabout
parts list
M
B
H
I
K
D
J

assembly
step 1
Remove screws from pole (B), line up end of pole (B) with leg
sections (A) and insert screws and curved washers (H). Repeat
with second pole (B).
NOTE: Position curve of black plastic end cap of pole (B) to
match leg section (A) angle.
step 2
Place cushioned pad (D) on floor face down.
step 4
Insert all four legs (G) into leg section (A) at desired height.
step 1
Insert push handle bracket (E) into mounting tube (L) on the
back leg section. Make certain that the push button clicks into
hole on underside of mounting tube on the front leg section.
Repeat on second side
step 1
Lay harness (M) on floor and place child on stomach on top of
harness. Place CrawlAbout above child. Attach side straps
to clasps on the underside of cushioned pad doing front side
clasps first. Attach the back straps and then the shoulder
The CrawlAbout can be used with or without
push handles.
To use with push handles:
step 2
Insert push handle (F) into bracket (E) at desired height.
Repeat on second side.
operation
step 2
Adjust harness straps length as needed.
step 3
Adjust leg height to appropriate height.
A
B
step 3
Place frame over the pad inserting all four screws ( C) into
frame. Align front of frame with front of pad (Frame and
pad are marked front and back.) Install four nuts (I) onto
screws (C). Cover nuts with black caps (J).
L
When using without push handle insert large
black end cap (K) into mounting tube (L) on the
back leg section.
C