aidapt VM947A Programming manual

EN
Rigid Sock & Stocking Helper
VM947A
Usage and Maintenance Instructions

Usage and Maintenance Instructions Ver. 2 08/2012 (1713)
2
INTRODUCTION
Thank you for deciding to purchase the Rigid Sock & Stocking Helper from
Aidapt. When used correctly it is designed to give many years of reliable
trouble-free service.
BEFORE USE
Carefully remove all packaging. Avoid using any knives of other sharp
instruments as this may damage the surface of the product.
Check the product for any visible damage. If you see any damage or suspect
a fault, do not use your product, but contact your supplier for support.
INTENDED USE
The Rigid Sock & Stocking Helper makes putting on socks, tights (pantyhose)
or stockings easy.
INSTRUCTIONS FOR USE
Using the Rigid Sock & Stocking Helper is simple:
•Stretch the sock or stocking inside out over the shorter, middle section
of the Sock & Stocking Aid.
•Push the foot into the toe of the sock/stocking.
•Using the two metal handles, pull the Metal Sock & Stocking Aid up
the calf, this will pull the sock or stocking up at the same time.
•When the sock/stocking is fully extended and fitted to the calf, slightly
lift the Metal Sock & Stocking Aid to release it from the sock/stocking.
•You can then remove your leg from the Metal Sock & Stocking Aid.
CLEANING
Clean your Metal Sock & Stocking Aid using a non-abrasive cleaner or mild
detergent with a soft cloth. Abrasive cleaners e.g. AJAX and/ or abrasive
cleaning pads may damage the product beyond repair and should not be
used. Always ensure that you wipe dry the equipment after cleaning.
REISSUE
If you reissue or are about to reissue this product, please thoroughly check all
components for their safety.
If in any doubt, please do not issue or use, but immediately contact your
supplier for service support.

Usage and Maintenance Instructions Ver. 2 08/2012 (1713)
3
CARE & MAINTENANCE
Please make a safety check of the product at regular intervals or if you have
any concerns.
IMPORTANT INFORMATION
Please exercise common sense and do not take any unnecessary risks when
using this product; as the user you must accept liability for safety when using
the product.
Please do not hesitate to contact the person who issued this product to you or
the manufacturer (detailed below) if you have any queries concerning the
assembly/use of your product.
Aidapt Bathrooms Ltd, Lancots Lane, Sutton Oak, St Helens, WA9
3EX
Telephone: [phone] •Fax: [phone] •
Web: www.aidapt.com
Email: [e-mail]