Medical Depot Drive junior User manual

junior rollator
www.drivemedical.com
lifetime limited
warranty
Your Drive brand product is warranted to be free of
defects in materials and workmanship for the lifetime of
the original consumer purchaser.
This device was built to exacting standards and care-
fully inspected prior to shipment. This Lifetime Limited
Warranty is an expression of our confidence in the mate-
rials and workmanship of our products and our assur-
ance to the consumer of years of dependable service.
In the event of a defect covered by this
warranty, we will, at our option, repair or replace the
device.
This warranty does not cover device fail-
ure due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable components, such as rubber
accessories, casters, and grips, which are subject to nor-
mal wear and need periodic replacement.
If you have a question about your Drive device or this
warranty, please contact an authorized Drive dealer.
© 2006 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
EU Authorized Representative
Drive International, LLC
Globe Lane - Stockport
DUKINFIELD SK16 4RE, GB

DONOTATTEMPTTOADJUSTOROPERATE
ROLLATORWITHOUTCAREFULLYREADINGALL
INSTRUCTIONSINTHISMANUAL
1. First remove all contents from carton: backrest,
handle with tube, Rollator frame and pouch.
2. Open frame and slide padded backrest into frame
brackets making sure snap bottoms protrude
through holes.
3. Unscrew tightening knob from handle and insert
handle tube into frame at desired height lining up
holes appropriately. Slide bolts through holes from
the inside and screw on tightening knob until
secure.
- Please make sure the Rollator is fully opened, seat
is down and the folding bar under seat is locked in
the down position.
- Be sure that both knobs are fully tightened and
are at equal heights. Test Rollator for stability
before applying full weight to hand grips.
- Test the loop locks before operating the Rollator.
When wheels are locked (see illustrations for locking
and releasing locks below), lock bar on rear wheels
should prevent wheels from turning. If the wheels
turn while brakes are locked, please take unit back
to dealer for adjustment. When locks are released,
the wheels should turn freely.
- Always lock loop locks before sitting and do not use
seat when unit is on an incline or uneven ground.
- Replace tires when significantly worn or damaged.
- Do not have anyone push you while you are seated
on the Rollator. THISISAWALKINGAIDONLYAND
ISNOTTOBEUSEDASATRANSPORTATIONDEVICE
Orthodic
Hand Grips
Height
Adjustable
Wide
Comfortable
Seat
Folding
Hinge for
Portability
Loop Locks —
Safest System
Available
Backrest
Sealed Wheel
Bearing for Smooth
Operation
Hanging
Basket for
Functionality
& Storage
assembly instructions
safety precautions
loop lock operation
ALWAYSENGAGEANDDISENGAGEWHEELLOCKS
ONBOTHSIDESSIMULTANEOUSLY
1. To Slow Down or Come to a
Temporary Stop — Pull up slowly
on the loop locks with four
fingers until unit slows down or
comes to a temporary stop.
2. To Temporarily Lock Wheels in
Position — Press down on both
loop locks with palms until you
hear a “click” that will tell you
wheels are locked.
3. To Release Wheel Locks — Push
up on both loop locks with palms
of hand to original position.
Height
Adjustable
Wide
Comfortable
Seat
Folding
Hinge For
Portability
Sealed Wheel
Bearing for
Smooth Operation
Hanging Pouch
for Functionality
& Storage
Backrest
Loop Locks -
Safest System
Available
Orthodic
Hand Grips