Medical Technology Tenease User manual

User Manual
Troubleshooting/Warranty
If the unit does not function, ensure that the battery is not spent and is
inserted in the correct orientation and the cap fully screwed on. If the
unit still does not function when the start/stop button is depressed, the
unit should be returned to the manufacturer.
The unit is designed to be used for a maximum of 3 treatments a day.
Excessive use of the unit beyond the recommended treatment cycle
can result in damage to the mechanical parts and render the
manufacturers warranty invalid. The unit does not contain any
serviceable parts, and any attempted repair or modification to the unit
will invalidate the warranty. This does not affect your statutory rights.
Battery Information
The unit utilises 1 x AAA battery (supplied with the unit). *Remove the
battery if the product is not in use for prolonged periods. *Remove
spent batteries from the unit. *Dispose of batteries safely. *Batteries
should be handled by an adult, keep out of the reach of children.
* Warning: If batteries leak, avoid contact with skin. In the event of
contact, wash immediately with copious amounts of water. If irritation
persists, seek medical assistance.
Medical Technology Ltd, PO Box 223, Harbour Court, Les Amballes,
St Peter Port, Guernsey, GY1 1WU
Tel: [phone]
Email: [email protected]
Website: www.tenease.com
Manufactured in UK by MTL
Company Registration No: 51663 Doc Ref: IFU_03. Revision 4. Date: 11.12.15
0088
Introduction
Thank you for purchasing your Tenease mobile
pain relief device. The Tenease is the first
device specially designed for the alleviation of
the pain associated with lateral or medial
epicondylitis, more commonly referred to as
Tennis or Golfer’s Elbow.
How Does Tenease Work?
Epicondylitis is a common cause of elbow pain,
characterised by pain over the outer side of the elbow,
which may radiate down the forearm. Despite the names
Tennis and Golfer’s Elbow, epicondylitis does not just afflict
tennis or golf professionals. In fact, this common elbow
problem affects around 2% of the population and is most
often associated with work related activities.
The cause of the condition is a lack of inflammation in the
tendon, often due to a restricted blood supply. Microscopic
tears in the tendon cause pain and a lack of grip strength,
and healing is slow due to the lack of blood flow.
The Tenease device generates high-frequency vibrations
which travel as shockwaves to the affected area. Pain is
transmitted as impulses in the large sensory fibres of the
body and by applying a signal to the area of pain, it
interacts with the pain impulse transmissions causing
disruption. The vibration is effectively ‘scrambling’ the
sensory impulses to the extent that they cannot be
interpreted as pain signals by the brain.
Strap the device to the appropriate part of the elbow and
press the start button to start the treatment. This operates
the device. After a period of 10 minutes, press the button
to stop. Multiple treatments can be consecutively
administered with a maximum of 3 treatments a day. This
treatment pattern has been shown to relieve the pain
associated with epicondylitis for as long as 4 to 6 hours.
Before use, please read all of the instructions in this user
manual carefully and retain for future reference.
Symbol Descriptions
Address of Manufacturer
Caution, Consult
Accompanying
Documents.
Type B Applied Part
Upper and Lower Storage
Conditions
Consult Instructions
for Use
On/Off Button
Specification
• Power Source: DC 1.5V (1 x
AAA battery)
• Frequency: 150Hz nominal
• Approximate Dimensions:
100mm x 37mm x 32mm
• Weight (incl battery): 60g
• Operating Conditions: 5°C to
40°C; <90% RH
• Storage/Transport Conditions:
0°C to 45°C; <90% RH
Disposal
This device is covered by the WEEE regulations that
require manufacturers to collect waste electrical
equipment for recycling/disposal. To arrange free of
charge collection/disposal of this product, please call
0845 680 9635 or visit our website www.tenease.com.

Instructions for Use
1. Parts
The product consists of a Tenease unit, strap and one AAA battery
Cleaning Instructions
Wipe the outer unit with a dry cloth. The strap can be washed in
warm soapy water. Do not immerse unit in water.
2. Preparation for Use
The unit requires 1 x AAA
battery (included).
Before use, unscrew the
battery cover cap and remove
the battery insulation tab. Remove
any packaging from the battery.
Re-screw the battery cover cap tightly.
Always insert the battery carefully, taking care to insert
in the correct orientation. Inside the battery compartment
the terminals are identified with a ‘+’ and ‘-’.
3. Using the Unit
4. Fitting the Unit
In order to optimise the performance of the device, the nozzle on the lower
side needs to be placed over the area where pain is being experienced.
The strap is then secured in order to hold the device in place while not
restricting the blood flow to the lower arm by ‘over-tightening’.
The start/stop button on the battery cover is then depressed in order to
activate the unit. The Tenease can be stopped or started manually at any
time by depressing the start/stop button. Do not exceed a 10 minute cycle
each time you use the device.
It is recommended that the Tenease is used for 30 minutes each day, in
separate 10 minute treatments.
Epicondylitis is now known to be caused by a lack of inflammation of the
tendon. As inflammation is caused by the device to encourage blood flow
and tendon repair, you may experience some soreness around the elbow
area when first using the device. This is normal and a sign that your device
is working correctly. You can use the device for less than 3 cycles per day,
or for a shorter time, until any soreness has gone.
Battery
Cover
Strap Slot
Start / Stop
Button
Vibration
Head
Warnings and Safety
Before using the device, please read and understand the following warnings
to ensure the safe and correct use of the device and to prevent any injury.
• Ensure there is no leakage from the battery. If the battery shows any
evidence of leakage, see section ‘Battery Information’.
• Ensure the battery is installed correctly.
• The device is designed for use on the elbow and lower arm; do not
use on any other part of the body.
• If you feel unwell or experience any discomfort at any time, stop using
the device immediately.
• If you notice any reddening of the skin, stop using the device immediately.
• Only apply the device to normal skin. If suffering from a skin condition
or new scar tissue is present in the area of application, seek medical
advice before use.
• Do not disassemble, repair or modify the device in any way, as this
will invalidate the warranty and may lead to malfunction of the device
or an injury.
• Do not use the device while sleeping.
• Do not immerse the device in water or any other fluid.
• Do not throw or drop the device from a height. The unit should not
be used if any physical damage is evident.
• Do not use any chemicals to clean any part of the unit.
• Only to be used by persons over the age of 16 years old.
• Medical electrical equipment requires special precautions regarding
electromagnetic compatibility (EMC) and must be installed and used
according to the instructions contained in this manual. Portable or
mobile radio communication equipment may affect medical
electrical equipment.
Thread the strap through the slot
below the battery compartment
with the fibrous side facing the
battery compartment.
Loop the end of the strap through the
black end buckle and place on the
arm with the front (tapered end) of the
unit pointing towards the shoulder.
The unit can now be secured by
folding the Velcro strap back on
itself and attaching the end of the
strap onto the fibrous surface.
Identify the area of pain and place
the nozzle of the unit directly over this
point. The unit can now be operated
by pressing the start/stop button.
Fibrous side Insert
arm here
Pull strap
down to
tighten
Press here