Mercia Garden Products ESDXL21PT032 User manual

PREMIUM WOODEN TRIPLE BIN STORE

Side wall 2pcs
Front rail 3pcs
PREMIUM WOODEN TRIPLE BIN STORE
ASSEMBLY INSTRUCTION
Door 3pcs Lid 3pcs
Middle frame 1 8pcs
Middle frame 2 12pcs Connection bar 9pcs
Back wall support 12pcs
Handle 3pcs Chain 3pcs Tower bolt 3pcs Hinge 12pcs
Before assembly
•We recommend that time is taken to
read the instructions before starting
assembly, then follow the easy step
by step guide.The instruction sheet
is only a guide to the assembly.
Certain items may not be shown to scale.
•Check all components prior to assembly
•This product should be assembled
by no less than two people.
•Never attempt to erect the assembly
in high winds.
•Drill all components where indicated.
Recommended tools for assembly:
•Drill with 3mm diameter drill bit
•Cross head screw driver
•Hammer
3mm PZ 2 X2
No Fixing kit Qty
1
70mm screws
24
2
60mm scres
18
3
50mm screws
16
4
40mm screws
48
5
30mm screws
36
6
20mm screws
78
7
25mm round head screws
3

Middle frame 1
Middle frame 2
70mm
screws
Side wall
Middle frame
Connection barConnection barConnection bar
Back wall
support x4
Left side section
Middle section
middle frame
middle frame
connection barconnection barconnection bar
back wall
support
Drill the pilot holes
for the screws
Front rail
25mm
screws
50mm
screws
2. Side Panels and Middle Section
Secure the three pcs of the connection bars between
one of the side wall panels and the middle frame
using 6 x 60mm screws. Back wall corner supports
secure with 4x40mm screws per one support.
Repeat this procedure to connect the right hand
wall section. In the middle section connect the
connection bars between the two middle frames.
1. Middle Frame
Connect the 2 no of the vertical frames and the 3 no of
the horizontal frames as shown below using 6 x 70mm screws.
Repeat this procedure to connect three other middle frames
in the same way.
60mm
screws
3. Connection of the Wall Panel Sections
Secure the middle section between right
and left hand wall sections as shown on the
drawing using 16 x 50mm screws.
The metal rail connects with 20mm screws.
Drill the pilot holes
for the screws

20mm
screws
30mm
screws
20mm
screws
20mm
screws
25mm round
head screw
4. Doors
Position a tower bolt at the top of the each door
and their catch plates on the middle frame
as shown. Ensure the bolts align with the
catch plates so that the bolts fits in the catch
plate when in the locked position. Secure
each bolt using 4 x 20mm screws and
2 x 20mm screws for each catch plate.
Secure two hinges to the each door
using 3 x 30mm screws per hinge.
Position the doors in place and
mark the right hinge position on
the side wall front frames. Open the
doors and fix the hinges to the side
wall front frames using 3 x 30mm
screws per hinge.
5. Lids
Place the three lids on to the body of the
assembly and at the back attach two
hinges per lid and fix with the 6x20mm
screws per hinge.
6. Handles, chains
Attach the handles to the front of the
lids using 4x20mm screws per handle.
Attach one chain to each lid. Screw
through the end link of each chain into
the side of the lid frame as shown using
1 x 25mm round head screw.