Merit MT-203 User manual

MT-203
MT-203
MT-203 MR-203
MR-203
Switch to control LED on/off.
Knob
in 1
PP/îPP:îPP+
&+*+=)+665$',2&21752/6<67(0 3.7V

2
Wheel Throttle
（CH1)
6
5
4
3
2
1
Antenna Wire
%UDNH212))
&+
&+
&+
Swith
Power
Battery
Motor

/('%UDNH

/('%DFNZDUG

/('%UDNH212))
%DFNZDUG/('
%UDNH/('
Receiver
Power Switch
CH1
Steering Trim
Power/Bind
Indicator
CH3
Reverse CH1
Throttel
Coutrol Switch
Bind
Button
Steering Dual
Rate Knob（D/R)
&+*+=)+665$',2&21752/6<67(0

3
MR-203
Motor
Battery
Swith
L
E
D
LED
&+*+=)+665$',2&21752/6<67(0

4
MR-203
Bind
Steering Trim Knob
Throttle Trim Knob
+
THROTTLE CONTROL SWITCH
Low，Middle，High speed selection.
To set throttle control rate by adjusting
the switch to high ，middle and low rate per your selection.
Press the Bind button and power on the transmitter LED on transmitter will flashing.
Receiver LED flashing,when it goes to solid , binding is completed
LMH
knob
adjusting
adjusting
Then power on the receiver
&+*+=)+665$',2&21752/6<67(0

&+*+=)+665$',2&21752/6<67(0

FCC Statement：Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference，and (2) this device must accept any interference received, including interference that may cause undesired operation. RF exposure statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The device has been evaluated to meet general RF exposure requirement . The device can be used in portable exposure condition without restrictionThe distance close to the finger usually should be 20mm.Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help.
Warning words