Metsys MP3 User manual

METSYS MP3 Point Laser
The MP3 point to point self-leveling laser provides effective layout solutions
compared to tradition old methods. The unit projects three highly visible dots
instantly from ground floor to ceiling and forward off the ground. Contractors can
use it for layout reference, point transfer, ceilings and more tasks. The laser is built
with an anti-shock rubber housing, which enables it to survive in tough job sites.
MP3 Product Overview
Tough over molding
housing
Pendulum Lock
Battery Door
On/ OFF button
Top Laser window
Front Laser window
Plumbing Laser window
1/4 screw thread

METSYS MP3 Point Laser
Safety Instructions
Please read thoroughly and comply with the Safety Instructions and User Manual before using
this product. Failure to read and follow may void the warranty.
WARNING!
Class 2 Laser Product
Max. Power Output: ≤ 1mW
Wavelength: 635nm-640nm
LASER RADIATION:
DO NOT STARE INTO BEAM.
DO NOT DIRECT EYE EXPOSURE.
ACOID VIEW WITH OPTICAL INSTRUMENTS.
ATTENTION:
Read all instructions prior to operating this laser tool. Do not remove any labels from tool.
• Do not set up the laser tool at eye level or operate the tool near a reflective surface as the laser
beam could be projected into your eyes or into the eyes of others.
• While the product is in operation, be careful not to expose your eyes to the emitting laser beam
(Green/Red light source). Exposure to a laser beam for an extended time may be hazardous to
your eyes.
• Do not attempt to view the laser beam through optical tools such as telescopes, as serious eye
injury may result.
• Do not disassemble or modify the laser in any way. Modifying the tool may result in hazardous
Laser Radiation Exposure.
• Do not operate the laser around children or allow children to operate the laser. Serious eye
injury may result.
• An exposure to the beam of a Class 2 laser is considered safe for a maximum of 2 seconds.
Eyelid reflexes will normally provide adequate protection.
• The following label/print samples are placed on the product to inform of the laser class for your
convenience and safety.
Self-leveling Mode
• is enabled when the laser tool is switched to the unlocked position and when you Press the
On/Off button
•When the laser plumb blink fast, the unit is out of its self-leveling range (±3°).
Note: When using Self-leveling mode, please place this laser tool on a level surface.
Manual Mode
• Slide the pendulum switch to the Locked Position, then press the Laser button and hold for 3
seconds to turn on to manual mode.
• The laser beam(s) will blink about every 3-5 seconds to notify the user

METSYS MP3 Point Laser
Specifications
Model
MP3
Laser Wavelength
635-640nm
Laser Class
Class 2 (IEC/EN60825-1/2014), ≤1mW
Leveling Accuracy
±3mm/10m
Fan angle
H: 360 ° / V: 140°
Leveling/Compensation
Range
±3°
Operation Temperature
Range
0℃~＋45℃
Storage Temperature Range
-20℃~＋60℃
Operating Time (all laser
beams on)
Min 20 Hours ( 3 AA)
Working Distance (Dot)
30m
IP Rating
IP54
Mount Size
1/4”-20
Power Source
3×˝AA˝ (LR6) /
Note:
Appearance and specifications may differ due to product improvement.
Working distance varies depending on the operating environment.
Battery life depends on battery capacity and quality, it is recommended to use a large capacity
battery.