mFi mFi-DS User manual

Door Sensor
Model: mFi-DS
Introduction
Thank you for purchasing the
Ubiquiti mFi™
mFi-DS is designed for use with

connected, you can use the mFi
Controller software to monitor
your sensors using your Web



Switch
Magnet
Screw
Terminals
Switch Features Screw Terminals
and attaches to the frame of the

Magnet Attaches to the door or

Installation Requirements
 
 
 

Installation Tips
 For optimal performance,
use one of these end-to-end
configurations:

 
configuration:
 
Max. 20 mm
 
you install the mFi-DS as high up
as possible, either at the top or on




Ubiquiti Networks Support
Email: suppor[email protected]om
Phone: [phone]


Wiki Page: wiki.ubnt.com
Support Forum: forum.ubnt.com
Downloads: downloads.ubnt.com


Door Sensor
Model: mFi-DS
Wiring Instructions
Perform these steps to connect the
wire from the Switch to the mPort:
 Insert each pre-stripped wire at
one end of the 
 into each Screw Terminal

 Tighten each Terminal Screw
 
, repeat steps 1-2 to
connect the wire to the Iand O
Terminals of the 


 Connect the  to
the 

Mounting Instructions


 
 
!

 Mount the Magnet onto the


 Align the Switch with the
Magnet so their edges line up
when the door or window is


 Mount the Switch onto the

Refer to the User Guide on the

your mFi mPort for instructions on
configuring the mFi-DS in the mFi


www.ubnt.com/mfi