MGG EF-SRD12-3500LEDSA User manual

1
ELECTRIC FENCING ENERGIZER
USER MANUAL
Model: MGG EF-SRD12-3500LEDSA
For up to 100Km wire

2
Contents
1. Introduction........................................................................................3
2. Important safety introduction...........................................................3
3. Specification......................................................................................6
4. Installation guide...............................................................................6
5. Maintenance......................................................................................7
6. Guarantee..........................................................................................8

3
Foreword
Thank you for buying an MGG electric fence energizer. This Energizer has built-in RFI
(Radio Frequency Interference) Suppressed Circuitry.
In the unlikely event that you are not happy with your purchase, please return the
energizer in new condition to MGG within 14 days of purchase and we will give you a full
refund (excluding freight). If you have any questions regarding this product please email
us: [e-mail] or freephone us on 0800 449 669
Please read this manual carefully before using this product and keep it handy. If you have
problems in the process of use you can read it again. Do not let children operate or play
with an electric fence energizer.
1. Introduction
This manual describes the MGG electric fence energizer model :
MGG EF-SRD12-1000A
2. Important safety introduction
WARNING: Please read all instructions
⚫Do not touch a live fence
⚫Do not drench with water.
⚫This product is for use in controlling livestock. Any other use is
prohibited.
⚫Keep fence clear of weeds, branches etc to avoid electrical shorts resulting
in battery drainage.
⚫Do not climb over, through or under a multi -wire electric fence. Use a gate
or a specially designed crossing point.
⚫Do NOT become entangled in the fence. Avoid electric fence constructions
that are likely to lead to the entanglement of animals or persons.
⚫Electric animal fences shall be installed and operated so that they cause
no electrical hazard to persons, animals or their surroundings.
⚫It is recommended that in all areas where there is a likely presence of
unsupervised children who will be unaware of the dangers of electric
fencing, that a suitably rated current limiting device having a resistance of
not less than 500 ohms be connected between the energizer and the
electric fence in this area.

4
⚫The appliance is not intended for use by young children or infirm persons
without supervision.
⚫Do not place combustible materials near the fence or energizer
connections. In times of extreme fire risk, disconnect energizer.
⚫Don't dismantle. Don't make any changes to this energizer. Don't touch
high voltage parts which can cause electric shock. This energizer is not
user-serviceable.
⚫Young children should be supervised to ensure that they do not play with
the appliance.
⚫An electric animal fence shall not be supplied from two separate
energizers or from independent fence circuits of the same energizer. That
is very dangerous.
⚫For any two separate electric fences, each supplied from a separate
energizer independently timed, the distance between the wires of the two
electric animal fences shall be at least 2.5m.
⚫Barbed wire or razor wire must not be electrified by an energizer.
⚫A non-electrified fence incorporating barbed wire or razor wire may be
used to support one or more off-set electrified wires of an electric animal
fence. The supporting devices for the electrified wires shall be constructed
so as to ensure that these wires are positioned at a minimum distance of
150 mm from the vertical plane of the non-electrified wires. The barbed
wire and razor wire shall be earthed at regular intervals.
⚫Where an electric animal fence crosses a public pathway, a non-electrified
gate shall be incorporated in the electric fence at that point or a crossing by
means of stiles. At any such crossing the adjacent electrified wires must
carry warning signs.
⚫In areas of public access, use an electric fence warning sign every 10m
(33ft) to identify the electrified wire(s).
⚫Crossing with overhead power lines should be avoided wherever possible.
If such a crossing cannot be avoided, it should be made underneath the
power line and as nearly as possible at right angles to the power line.
⚫If connecting leads and electric fence wires are installed near an over head
power line, the clearances should be not less than those shown below:
Power Line Voltage
V
Clearance
M
≤1000
＞1000 ≤33000
＞33000
3
4
8
⚫If connecting leads and electric fence wires are installed near an over head
power line their height above the ground should not exceed 3m.
This height applies either side of the projection of the outermost
conductors of the power line on the ground surface, for a distance of:

5
• 2 m for power lines operating at a nominal voltage not exceeding 1000V;
• 15 m for power lines operating at a nominal voltage exceeding 1000V.
⚫Electric animal fences intended for deterring birds, household pet
containment need only be supplied from low output energizers to obtain
satisfactory and safe performance.
⚫Fence wiring should be installed well away from any telephone or
telegraph line or radio aerial.
⚫The size of the warning sign shall be at least 100mm x 200mm.
⚫The background colour of both sides of the warning sign shall be yellow.
The inscription on the sign shall be black and shall be either:
-the substance of “CAUTION: Electric Animal Fence” or,
-the symbol shown:
⚫The inscription shall be indelible, inscribed on both sides of the warning
sign and have a height of at least 25mm.
⚫Ensure that all mains operated ancillary equipment connected to the
electric animal fence circuit provides a degree of isolation between the
fence circuit and the supply mains equivalent to that provided by the
energizer.
⚫Protection from the weather shall be provided for the ancillary equipment
unless this equipment is certified by the manufacturer as being suitable for
use outdoors and is of a type with a minimum degree of protection IPX4.
This energizer complies with international safety regulations and is
manufactured to international standards. MGG reserves the right to make
changes without notice to any product specification to improve reliability,
function or design.