2 | P a g e
Rev 3.01
1.2 Features
Integrated controller/driver for Micronix stick-slip piezo motors
Compact, modular design allows for bench-top or standard 2U height rack mounting
Configurable as a standalone unit or stackable up to 16 axes
Open loop/closed loop operation
Open loop resolution of less than 1 nm
Closed loop resolution dependent on the encoder (typically 1 nm)
A quad B differential or sin/cos analog encoder feedback
USB 2.0 or RS-485 interface (one interface for up to 99 axes)
Windows GUI, DLL and LabVIEW VI
1.3 Package Contents
If product is damaged or there are missing components, contact Micronix USA
immediately. Do not discard product packaging in case of return shipment.
Package Contents:
MMC-100 Controller
User Manual
Supplemental CD
Power Cable
2. Quick Start Guide
2.1 Quick Start Guide Overview
The following Quick Start Guide is intended to provide a basic set-up of the MMC-
100 in the least amount of time. The following paragraphs will provide a
walkthrough of the steps needed to set-up the controller and verify that the
system is working correctly.
Caution: In the case of custom and/or vacuum wiring this guide may not
portray the wiring with which your system was supplied. Please consult the custom
wiring diagram included with your custom/vacuum shipment.
1. Install Drivers
a. To ensure correct communication between the module and PC, install
the proper drivers onto the communicating computer prior to
connecting the MMC-100.
b. The drivers may be found on the supplemental installation CD or can
be downloaded from:
http://www.ftdichip.com/Drivers/VCP.htm
c. For more on how to properly install drivers, see the appropriate
installation guide included on the supplemental CD or on the website
above.
