Miele DG 155-2 User manual

Installation instructions for the
DG 155
DG 155-1 / DG 155-2
Steam oven
To prevent accidents and
machine damage,
read these instructions
before installation or use.
UV
05 229 050
M.-Nr.

General Notes. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Appliance and cut out dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Installation in tall cabinetry . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Installation under a counter top . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Installation above a Miele oven . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Installing the oven . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Securing the oven . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Contents
2
Important - Save for the local electrical inspector's use

Installation
This equipment has not been de-
signed for maritime use or for use
in mobile installations such as aircraft
or recreational vehicles. However, un-
der certain circumstances it may be
possible for an installation in these ap-
plications. Please contact the nearest
Miele Dealer or the Miele Technical Ser-
vice Department with specific require-
ments.
This steam oven is designed for instal-
lation in cabinetry or beneath a counter
top.
Keep these installation instructions in a
safe place and pass them on to any fu-
ture user.
Illustrated dimensions are in millime-
ters. For converting to inches, use the
enclosed table.
General Notes
3

Installation in tall cabinetry
aSteam oven
bCabinet opening
cTerminal block
dOutlet or junction box. This should be accessible after the appliance has been
installed.
ePower supply cord
Appliance and cut out dimensions
4
b
c
df
e
23
17
13
"
13
"
78
"
916
"
21
22 22
58
"
716
"
17
11
16
"
116
"
17
15
16
"
23
13
"
916
"
456mm)
450mm)
595mm)
560-568mm)
330mm)
22mm)
min.330)
547mm)
447mm)
100mm)
15 16
"
3
38
"
-
17
13
"
78
"
21
22 22
58
"
716
"
17
11
16
"

Installation under a counter top
aSteam oven
bCabinet opening
cTerminal block
dOutlet or junction box. This should be accessible after the appliance has been
installed.
ePower supply cord
Appliance and cut out dimensions
5
c
df
b
e
min.370)
456mm)
595mm)
560-568mm)
447mm)
17
58
"
716
"
23
916
"
21
17
15
16
"
916
"
547mm)
916
"
14
330mm)
22mm)
13
"
78
"
21
116
"
38
"
-
22 22
450mm)
17
11
16
"

Installation above a Miele oven
aSteam oven
bCabinet opening
cTerminal block
dOutlet or junction box. This should be accessible after the appliance has been
installed.
ePower supply cord
gOven
Note:
The steam oven must be supported by ledges or shelving. It must not rest di-
rectly on top of the oven.
Appliance and cut out dimensions
6
550mm)
b
g
c
c
de
f
17
13
"
13
"
78
"
78
"
9
9
16
16
"
"
58
"
9
9
16
16
"
"
450mm)
593-595mm)
560-568mm)
560-568mm)
330mm)
22mm)
22mm)
min.330)
560mm)
547mm)
447mm)
580mm)
100mm)
15 16
"
3
17
78
"
78
"
58
"
21
21
116
"
38
"
-
22 22
116
"
38
"
-
22 22
116
"
22
58
"
22
13 16
"
17
15
16
"
23
7
16
"
23
23
456mm)
596mm)
595mm)
716
"
716
"
17
11
16
"
23 - 23
7
3
16
8
"
21

Securing the oven
After aligning the oven it must be se-
cured in position.
Open the oven door and using the sup-
plied screws g, secure it to the cabinet
through the holes on either side of the
vertical oven trim.
Installing the oven
7

All electrical work should be performed
by a licensed electrician, in strict accor-
dance with national and local safety
regulations and standards.
–Note to installer:
Please leave these instructions with
the consumer.
–Power supply:
Please check the dataplate for verifi-
cation of:
240 VAC; 60 Hz
15A, 240 V
L1, L2, Ground
Caution:
Disconnect main power supply be-
fore servicing. To reduce the risk of
electrical shock, make sure that the
appliance is properly grounded after
installation.
WA NING : THIS APPLIANCE
MUST BE G OUNDED
For USA only
The appliance is provided with 3 termi-
nal leads, 1 black wire (L1), 1 red wire
(L 2) and 1 green wire (GND) which
have to be connected to a dedicated
junction box. Connect the black wire to
L1, the red wire to L2 and the green
wire to GND.
ALSO SEE THE WI ING DIAG AM
P OVIDED WITH THE APPLIANCE.
For CDN only
The appliance is provided with 3 termi-
nal leads: 1 black wire, 1 red wire and 1
green wire which have to be connected
to a separate overcurrent protection de-
vice (fusebox or circuit breakers).
All hot wires (black and red) have to be
fused individually before connecting
them to the main power supply leads.
Use 15 Amp fuses or circuit break-
ers for appliances rated 240 VAC.
Connect black terminal wire to L1
(black) and red terminal wire to L2
(red). The green terminal wire (ground)
has to be connected directly to the
equivalent colored power supply leads.
All connections must be done in a
proper way.
ALSO SEE THE WI ING DIAG AM
P OVIDED WITH THE APPLIANCE.
Installing the oven
8

9

10