
TROUBLE SHOOTING
7
Battery type NI-CD 3.6V, 800mAh
Charging time 6h±0.5h
Charger output 4.0V----220Ma
Charger input 220V~50Hz, 100mA
Run time 90minutes
Walking speed: 23m/minute
Product size: Φ210 x 64.7mm
Net weight Approx 500-550g
Special function Microcomputer controller, overcharge
and over-discharge protection,
full-charge indicator
Problem Possible reason Problem solution
Poor cleaning and
dust pick up.
1. Electrostatic pad is too dirty.
2. Electrostatic pad is humid.
3. Electrostatic pad is not fixed
correctly.
1. Dispose pad and insert a new
one.
2. Dispose pad and insert a new
one.
3. Verify pad is correctly fixed to
the velcro on the soft base.
Important to avoid wrinkles on
the pad.
Unit moves slowly or
in small circles.
1. Battery low.
2. Disposable pad is too dirty.
3. Electrostatic pad is humid.
4. Floor is wet.
5. Wheels blocked (e.g. Hair, fluffs).
1. Recharge battery for
6h±0.5h.
2. Dispose pad and use a new
one.
3. Dispose pad and use a new
one.
4. Make sure you use only on
dry floors.
5. Clean wheels.
No light when
charging.
1. Charger not fully pushed into main
socket.
2.Charger not fully plugged into the
charging socket of the unit.
3. Defective main socket or charger.
1. Push the charger fully into
main socket.
2. Check charger cord is fully
engaged into the charging socket
3. Contact distributor
Unit fails to operate. 1. Battery flat.
2. Battery is damaged or mechanical
defect.
1. Recharge battery for
6h±0.5h.
2. Contact distributor.
Cleaning time too
short.
Battery flat. Recharge battery for 6h±0.5h .
For further help, technical advice, or to order spare or replacement
part, contact distributor.
TECHNICAL SPECIFICATION