Mini MN31 User manual

FRS
Channel Frequency Channel Frequency
1 462.5625
12 467.6625
2 462.5875
13 467.6875
3 462.6125
14 467.7125
4 462.6375
5 462.6625
6 462.6875
7 462.7125
8 467.5625
9 467.5875
10 467.6125
11 467.6375
Channel List :

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determind by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the follwing
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
■LicensingInformation
MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
This radio complieswith IEEE and ICNIRP exposure limits for General Population/Uncontrolled Environments RF
exposure emvironment at operating duty factors of up to 50% and is authorized by the FCC for General Population
use only. An appropriate warning lable is affixed to all units. In order to comply with RF exposure requirements, a
minimum distance of 2.5 cm must be maintained when held-to-face, and body-worn operations are restricted to the
approved original acessories (belt clip), a minimum distance of 0 cm. Do not use this device when antenna shows
obvious damages.
This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not
cause harmful interference.
SERVICE SIGNALS IS
PROHIBITED UNDER FCC RULES AND FEDERAL LAW.