MinimumRC F8F-RareBear Pro User manual

F8F-RareBear Pro
Assembly Instructions

1.Assemble the base.
2.Fold hinge for many times to make the rudder surface move freely (also
can be cut off and connected with transparent tape).

3. Cut off this part.
When the fuselage is combined, the screwdriver can be extended into the
adjusting steering arm.

4. Bond the fuselage, pay attention to the difference between the left and
right sides of the fuselage.
5.

6. Install aileron servo. The steering gear wire extends from the right side of
the fuselage.
7.Insert wing support, pay attention to both sides symmetrical.

8. Insert horizontal tail, pay attention to the symmetry of left and right sides,
glue bonding
9. Glue the motor to the nose. The coating sticker can be pasted on the
fuselage at this time.

10. Reference to coated stickers.

11. Fold the aileron back and forth many times to make the rudder surface
move freely. (It can also be cut off directly and connected with transparent
tape.)
Sticking transparent tape on both sides to enhance the torsional rigidity of aileron

12. Bend the wing along the notch.
13. Installation of the wing.

14. Installation of the control horns.
15. Connect the pushrod clips with heat shrinkable tube and fix them
with glue.