MinimumRC F8F Rare Bear Manual

F8F Rare Bear Install Manual
All manuals and user guides at all-guides.com
all-guides.com

1.Assemble the base
2.Cut the V-groove at the hinge of the rudder surface to make the
rudder surface active.
All manuals and user guides at all-guides.com

3.Bonding the body (note that the left and right side panels of the
fuselage are different)
4、Bonded finish fuselage
All manuals and user guides at all-guides.com

6、Insert the horizontal tail, pay attention to the left and right sides of
the symmetry
All manuals and user guides at all-guides.com

8、Decals
All manuals and user guides at all-guides.com

10、Sticking the wing (the line is facing down), pay attention to both
sides
All manuals and user guides at all-guides.com
all-guides.com

All manuals and user guides at all-guides.com

12、
All manuals and user guides at all-guides.com

13、
14、
All manuals and user guides at all-guides.com

15、The receiver is attached to the left side of the fuselage using a
Velcro, and fixed the cable with a tie.
All manuals and user guides at all-guides.com

16、The battery is fixed to the right side of the fuselage using a Velcro
All manuals and user guides at all-guides.com
all-guides.com

First Flight
·The center of gravity of the machine is 15mm from the front edge of the
wing. Please move the battery back and forth to adjust the center of gravity.
·The rudder amount are 5mm for each side of the movement. Please adjust
the rudder surface to the level before the test flight.
MinimumRC
All manuals and user guides at all-guides.com