Minuteman V14 PRO User manual

Excellence Meet s Clean
User Manual
2 Motor Upright

2
This manual is furnished with each new V14 PRO. This provides the necessary operating and preventive maintenance
instructions. Operators must read and understand this manual before operating or servicing this machine.
This machine was designed to give you excellent performance and efficiency. For best result and minimal cost,
please follow the general guidelines below:
· Operate the machine with reasonable care.
· Follow the manufacturer’s suggested maintenance instructions as provided in this booklet.
· Use original Minuteman supplied parts.
32”
(800 mm)
8.4” (210 mm)15” (360 mm)

3
Model V14 PRO
Model No. V14115P
Current Max
Vacuum motor power
Traction motor power
Working surface
Weight
Noise level
Voltage
Electronic card, motor blocking
Transmission
Air flow
Dust bag
Cable
Protection
Suction
14”
9.5 Amps
1150 W
150 W
14” (350 mm)
14.8 Amps
68 dB(A)
120 / 60 Hz
Provided
Poly V Belt
106 cfm (50 l/s)
61 cu.in. (6.5 l)
50 ft (15 m)
3-wire ground
104” of water (26 kpa)
Technical Specifications

4

5
Safety instructions ................................................................. 6
Unpacking instructions ......................................................... 7
Machine overview .................................................................. 8
Connecting the hose ............................................................. 9
Telescoping extension ........................................................... 10
Starting the brush .................................................................. 11
Checking the brush ............................................................... 12
Filter full indicator ................................................................. 13
Replacing the filter bag ......................................................... 14
Replacing the filter ................................................................ 15
Replacing the Hepa filter ...................................................... 16
Removing debris from the outer duct ................ 17
Removing debris from the inner duct ................ 18
Accessories provided ............................................................ 19
For safety during operation .................................................. 20
Warning ................................................................................... 21
Minuteman International Limited Warranty .................... 22-23
Table Of Contents

6
Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS
Operators must read and understand this manual before operating or maintaining this machine.
Do not operate this machine in flammable or explosive areas.
This machine is designed solely for vacuuming dirt and dust in an indoor environment. Minuteman does not recommend using this machine
in any other capacity.
The following information below may cause a potential hazard to the operator and equipment. Read this manual carefully and be aware
when these conditions can exist. Take necessary steps to locate all safety devices on the machine and train the personnel operating the
machine. Report any machine damage or faulty operation immediately. Do not use machine if it is not in proper operating condition.
FOR SAFETY DURING OPERATION
Keep hands and feet clear of moving parts while machine is in operation.
Make sure all safety devices are in place and operate properly. All covers, doors and latches must be closed and fastened before use.
During operation, attention should be paid to other persons in the work area and especially if small children are present.
Electric motors and components can cause an explosion when operated near explosive materials or vapor. Do not operate this machine
near flammable materials such as solvents, thinners, fuels, grain dust, etc.
Store or park this machine on a level surface only.
This machine is not suitable for picking up hazardous dusts.
FOR SAFETY WHEN SERVICING or MAINTAINING MACHINE
Stop on level surface.
Authorized personnel must perform repairs and maintenance. Use Minuteman supplied replacement parts.
SAVE THESE INSTRUCTIONS

7
Unpacking Instructions
INSPECTION
Carefully unpack and inspect your V14 PRO for shipping damage. Follow unpacking instructions on
shipping pallet. Each unit has been tested and thoroughly inspected before shipment. Any damage is the responsibility of the
delivery carrier who should be notified immediately.
Operator Responsibility
Read this manual carefully before operating this machine.
The operator is responsible for taking care of the daily maintenance and inspection of the machine to keep it in good
working condition. The operator must inform the service mechanic or supervisor when the scheduled maintenance intervals
are required as stated in the MAINTENANCE section of this manual.

8
Machine Overview
Machine Overview
A Ergonomic handle
B Power cord
C Hose
D Telescoping extension
E ON/OFF switch
F HI/LO vac motor switch
G Carrying handle
H Upper cord winding device
L Lower cord winding device
M Dust bag cover
N Vent grid
O Container
P Electric vac motor housing
Q Electric brush
R Base
A
F
R
H
G
E
N
B
C
D
Q
M
L
P
O

9
Machine Overview
Connecting the hose
Insert the swivel cuff into the bag-holding
sleeve, insert the other end of the swivel cuff
into the telescoping element, and hook the
hose to the handle.

10
Machine Overview
Operating the telescoping extension
Extend the telescoping extension by pulling
it; lock it by turning the dedicated ring nut
counter-clockwise.

11
Machine Overview
Starting the brush
Put your foot on the PUSH sign and tilt the
vacuum-cleaner body.
The brush automatically stops when the
handle is placed in the upright position.

12
Machine Overview
Checking the brush
The brush-checking device continuously
monitors the operation of the brush:
Green light: the brush is working correctly
Red light: the brush is either blocked or it is
undergoing excessive stress.
Turn the machine off, detach the plug from
the power source, and look for the cause of
the blockage.
LED

13
Machine Overview
Filter full indicator
If the “bag full” gauge turns red, please
verify:
a) whether the dust bag is full, or
b) whether the brush is clogged, or
c) whether the vacuuming hose is clogged;
in these cases, remove the obstruction
d) whether the Hepa filter is fully clogged.
It is normal that during vacuuming the “bag
full” gauge flashes red, because the
hose is partially closed.

14
Machine Overview
Replacing the filter bag
Remove the cover.
Place the dust bag into the container, by
inserting the bag-holding sleeve into the
dust bag hole and by pushing the safety ring
all the way in.
If the filter bag is not placed correctly,
closing the cover will be impossible.
1
2

15
Machine Overview
Replacing the filter
Pull out the filter holder and replace the
filter, or clean it by tapping it lightly
(replace it approximately every 20 bags).
Do not start the device without the filter
in place; the suction of foreign bodies will
damage the vacuum motor.

16
Machine Overview
Replacing the HEPA filter;
replacing or cleaning the pre-filter
Pull latch “A” in order to unhook the vent
grid; at the same time, slide it
(in the direction shown by the arrow) so that
it comes free. The pre-filter is housed in the
air exhaust under the HEPA filter. Replace
the pre-filter or clean it, by washing it with
water; dry it and carefully replace it in its
housing. Assemble the HEPA filter and the
vent grid again, by sliding it all the way in
until you hear the latch snap into place.
(A)

17
Machine Overview
Removing debris from
the outer duct
Any material clogging the hose can be
removed by detaching the telescoping
extension from its seat, turning on the
vacuum, and intermittently opening and
closing the wand end by hand.
Do not insert objects into the hose in order
to remove the debris.

18
Machine Overview
Removing debris from
the inner duct
Lay the vacuum body down flat and aligned
with the electric brush.
Unscrew the 1, 2 and 3 base screws, remove
the base.
Remove the clogged material from the duct
by using a flexible cleaning rod.
(3)
(1) (2)

19
Machine Overview
Accessories provided
1 - Small brush
2 - Crevice tool
3 - Curved sleeve
4 - Hose
5 - Telescoping extension
1
2
3
4
5

20
The V14 PRO
V14 PRO for safety during operations
This machine was designed with total operator comfort and ease of use in mind. All machine components have been
designed as a total system to efficiently clean dirty floors.
• Use extra care when cleaning on stairs.
• Never touch the rotating brush while in use.
• Do not run machine over the vacuum cleaner cord or any extension cord.
• Avoid picking up sharp objects. Always turn off the appliance before connecting or disconnecting the hose.
• If your cleaner is provided with a socket for connection to any other electrical appliance, please note the maximum power allowed,
ensure the plug will match the socket and check with your dealer for details.
• The plug connectors, the contacts of power socket must not come in contact with water.
These items may only be cleaned with a dry cloth, no moisture must touch them. Danger of electric shock.
• Clean the unit only with a dry or slightly damp cloth when disconnected from the power supply. Never immerse in water.
• Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
• Never use to pick up ammable or combustible liquids, such as gasoline, or use in areas where fumes
may be present.
• Do not put any objects into the openings. Never use with opening blocked, keep free of dust, lint, hair and anything that may
reduce the airow.
• Do not vacuum toner dust. Toner, such as that used in printers and photocopiers can conduct electricity.
• Do not use without dustbag and/or lters in place. Dustbags are disposable and intended to be used only once.
Do not attempt to reuse them.
• If your cleaner has the blowing function never use the blower to operate paint sprayers or similar devices that emit volatile
or toxic vapors.