
2
Important Safeguards
When using electrical appliances, in
order to reduce the risk of re, electric
shock and/or injury to persons, basic
safety precautions should always be
followed, including:
For Your Safety
Read all instructions carefully, even if you feel
you are quite familiar with the appliance.
Electrical safety and cord handling
• Voltage: Make sure your outlet voltage and
circuit frequency correspond to the voltage
stated on the appliance rating label. If it does
not match, contact our after sales support line
and do not use the appliance.
• Connection: Insert the plug properly into an
earthed mains socket. Make sure the socket
is within easy reach so the plug can easily be
removed if necessary.
• Electrical circuit: To avoid an electrical circuit
overload do not use a high waage appliance
on the same circuit with the Air Fryer.
• Do not immerse: To protect against electric
shock, do not immerse the cord, plug or the
electric base in water or other liquid. If the
base is accidentally immersed, immediately
unplug the power plug, dry the appliance and
have it checked by qualied service personnel.
• Protect from moisture: Do not expose the
electrical connections to water.
Do not use the appliance, or touch the plug,
with wet or damp hands, on a damp floor or
when the electric base is wet.
• Power cord: A short power supply cord is
provided to reduce the hazards resulting from
becoming entangled in or tripping over a
longer cord. Do not kink, bend, squash, strain
or damage the power cord and protect it from
sharp edges and heat. Do not let the cord
hang over the edge of a table or benchtop, or
touch hot surfaces.
• Damage: Check the power cord regularly for
visible damage. If it is damaged, it must be
replaced by the manufacturer, its authorised
service centres or similarly qualied personnel
in order to avoid any hazards. Do not pick up
or operate an appliance with a damaged cord
or plug, or after the appliance malfunctions or
has been dropped or damaged in any manner.
In case of damage, call our after sales support
line for advice on repair or return of the
damaged product.
• Unaended: Do not leave the appliance
unaended when plugged in.
• After use: Unplug the appliance after use.
Wait until it has cooled completely before
aempting to move or clean it.
• Disconnect: Always unplug the power cord
when the appliance is not in use. When
unplugging the appliance, grip by the plug, do
not pull by the cord.
• RCD: Unless your home is already ed with
a residual current device (safety switch), we
recommend installing an RCD with a rated
residual operating current not exceeding
30mA to provide additional safety protection
when using electrical appliances. See your
electrician for professional advice.
CAUTION: Hot Surfaces !
The Air Fryer and accessories will become very
hot during use. Do not come into contact with
heated parts while or after using the Air Fryer!
Only touch the handles and control panel while
the Air Fryer is in operation or immediately after
it has been switched o. The appliance needs
approximately 30 minutes to cool down. Wait
until the Air Fryer has cooled down and make
sure all components are clean and fully dry
before it is transported, cleaned or stored away.
Use oven gloves if necessary when handling the
hot accessories. Remove the baskets! Also be
careful of hot steam and air when you remove the
baskets from the appliance.
Free space: Do not place the appliance against
a wall or against other appliances. Hot air up
to 160 Degrees expels through the rear vent of
the appliance. Leave at least 30cm clearance
around the entire appliance, including directly
above it. Additional care should be taking when
placing appliances on bench top surfaces or near
splash backs where such materials (Acrylics,
timber etc.), do not have the high heat resistant
properties, so advise to place them on top of
a heat resistant material between bench and
appliance and further away from wall surfaces /
splash backs.
Safe distance: During the cooking process, Hot air
is released through the air outlet openings. Keep
your hands and face at a safe distance from the
hot air and form the air outlet openings.