Mobile Warming MW18A04-M4-10/W6-11 User manual

WWW.MOBILEWARMING.COM
FOLLOW US
PERFORMANCE HEATED SOCKS
USER MANUAL

Welcome to Warmth.
Stay Warm, Stay Comfortable
Thank you for purchasing our battery powered Bluetooth® Performance
Heated Socks. To ensure proper use and care of your Heated Socks and our
Mobile Warming batteries please read this user manual prior to use.
•One - Pair Performance Heated Socks
•Two - 3.7v 2000 mAh Lithium-Ion batteries (Model#MW37V22)
•One - 4.2v Dual AC battery charger (Model# ASA16U08)
Includes
Introduction
Patented Mobile Warming® technology is
specially engineered for cold environmental
conditions. Mobile Warming® comprehensive
heating solutions keep you warm and
comfortable. The exclusive Mobile Warming®
heating system utilizes F.I.R. (Far-Infrared) heat
and ultra-fine metal fiber heating elements
powered by lightweight, rechargeable, and
powerful Lithium-Ion batteries. As heat builds
Mobile Warming® advanced materials reflect
and direct heat back towards the body
ensuring that you stay warm. The combination of
unique materials, construction techniques, and
innovative design results in the most advanced
heated gear available.
REFLECTIVE LAYER
INSULATION LAYER
HEATED LAYER
F.I.R Technology
WWW.MOBILEWARMING.COM
WARNING
Only charge your battery with included compatible wall charger. Go to
www.mobilewarming.com/pages/battery-care for more information.
Do not store MW battery(s) below -4F(-20˚C).
Do not allow MW batteries or charger to come in contact with water or other liquids. If
water or other liquids enter the battery interior immediately unplug the garment from the
battery. Continued use of the garment may result in fire or electrical shock.
Do not expose battery(s) to direct flame or heat as the battery(s) may explode.
Disconnect MW battery pack from the garment(s) when not in use.
Garment(s) will discharge battery even when power is off.
It is important to maintain at least 25% of your battery power when not in use. Failure to
do so will result in performance issues and reduced battery life. We recommend to
charge your batteries every 3 months.
Recommended power settings of 50% is sufficient for temperatures between 50°-64°F
(10°-17.7°C) while at lower temperatures setting the power at 75% or 100% is sufficient. It
is not recommended to use 100% power setting for a long time as it may cause
overheating and /or bodily discomfort.
•
•
•
•
•
•
•

Power Ratings Based on Fully Charged Battery and Ambient Temperature of 72°
135°F
(57.2°C)
2.5Hrs.
100%
120°F
(48.8°C)
3Hrs.
75%
105°F
(40.5°C)
5Hrs.
50%
90°F
(32.3°C)
10Hrs.
25%
WWW.MOBILEWARMING.COM
Battery Installation
3.7volt Performance Sock Heat Ratings
Use only
MW37V22
Battery
5
6
Quick Start Guide
Fully Charge batteries to 100%.
Download MW Connect® from Apple App Store or Google Play Store and
follow MW Connect directions on next page to pair your mobile device to
the sock batteries.
Place socks on your feet.
Press and hold the power button on the battery for a few seconds. Once
it’s powered on LED will be Green/100% heat. Repeat for each battery.
Locate wire harness in battery stash pocket on inside of sock cuff (see
drawing).
Connect wire harness to battery and slide battery(s) in pocket (See
drawing).
Now that the batteries are connected to the socks and powered on;
Launch MW Connect on your Mobile Device to adjust heat settings.
To power off Socks, press and hold the power button on each battery until
light turns off. If you plan to not use socks for more than a few days, unplug
both batteries from the socks.
1-
2-
3-
4-
5-
6-
7-
8-
Do not use battery if you notice a
change of shape (lumps),
over-heating when charging or if
rust or corrosion on the battery
connectors is found.

Go to the Apple App Store or Google play store
and search “MW Connect”.
Install the MW Connect® App and enable
Bluetooth® on your mobile device.
Power on both Performance Sock batteries by
pressing and holding the power button for 3-4
seconds.
Launch the MW Connect® App. MW Connect will
auto-scan for both sock batteries.
In the garment listing, two sock listings will appear.
Click the first listing and rename “Username” to
something unique to you, for example, “John’s Sock
Left” or “John’s Sock A”.
How to Pair MW Connect App with Socks
Free Download
6-
7-
8-
9-
10-
11-
12-
WWW.MOBILEWARMING.COM
Now select the 2nd listing and rename “Username” to something
unique, for example, “John’s Sock Right” or “John’s Sock B”.
Select “Finish” at bottom of the app and the main screen will now be
displayed.
Leave both batteries powered ON and force quit the MW Connect
App to close it completely.
With the Performance socks batteries still ON, launch the MW Connect
App.
Under the Garment List, select each Sock (Do Not Rename) and select
“OK”.
After selecting “OK” for each sock, hit “Finish” at bottom of the App.
The main control screen will now be displayed within 5-10 seconds.
When pairing is complete, the socks icon will light up and you will now
have bluetooth® control of them.
Note: Once you successfully complete this pairing process MW
Connect will store your batteries in it’s memory.
1-
2-
3-
4-
5-

WWW.MOBILEWARMING.COM
Charging Instructions
To ensure the best battery performance and a
long battery life follow these steps. Battery Port
Charger Port
MW37V22
7.4volt 2200mAh
Lithium-Ion
ASA16U08
• Output: DC 4.2v, 0.75A
• Input : AC 100v-240v
Replacement or additional batteries and chargers available at
www.mobilewarming.com
Plug Mobile Warming charger into AC wall
socket and connect battery(s) to AC charger
connectors.
When indicator light(s) are “Red” battery(s) are
charging.
When indicator light(s) turn “Green” battery(s)
are fully charged and ready for use or storage.
Always charge batteries indoors.
Always use compatible Mobile Warming
Chargers to charge batteries. Failure to do so
could result in bodily injury, fire, or damaged
batteries.
•
•
•
•
•
Always disconnect and remove MW battery(s) from the garment(s) power
lead wiring harness.
Do not machine tumble dry, iron, or dry clean.
Do not wring out the garment(s) as this may cause damage to the heating
elements and or wire harness.
Do not fully submerse in water or other liquids.
Please charge the battery fully before use.
If problems with the battery occurs refer to caution label marked on battery
case or contact us at www.mobilewarming.com
Care Instructions
•
•
•
•
•
•
CAUTION
•
•
•
Only charge your battery with included compatible wall charger. Go to
www.mobilewarming.com/pages/battery-care for more information.
It is important to maintain at least 25% of your battery power when not in use.
Failure to do so will result in performance issues and reduced battery life. We
recommend to charge your batteries every 3 months.
Recommended power settings of 50% is sufficient for temperatures between
50°-64°F (10°-17.7°C) while at lower temperatures setting the power at 75%
or 100% is sufficient. It is not recommended to use 100% power setting for a
long time as it may cause overheating and /or bodily discomfort.

WWW.MOBILEWARMING.COM
Wash Instructions
•
•
•
•
Warranty Terms
*Our warranty applies only to the original purchaser and only for items purchased from an authorized
Mobile Warming Dealer or Authorized distributor retail partner.
Limited Two Year Warranty (Garment)
When you purchase a Mobile Warming brand product from an authorized Mobile Warming retailer
within the United States or Canada both the construction and electrical heating components of the
product are warranted to be completely free from factory defects in materials and workmanship for
two (2) year from the date of purchase. If any failure in the construction or the heating function of any
Mobile Warming product purchased from an authorized Mobile Warming dealer within the United
States and Canada occurs due to the manufacturer’s defect within two years of the purchase of the
product, the product will be repaired at no charge.*
90 Day Rechargeable Battery & Charger Warranty
Mobile Warming Gear rechargeable Lithium-ion battery packs and chargers are under warranty from
factory defect for 90 days from the initial purchase date. Mobile Warming will repair or replace any
battery or charger found to be defective under normal use within the 90 day warranty period.
*Costs associated with shipping the item in under warranty is the responsibility of the purchaser.
Warranty Exclusions
Any damage caused to any Mobile Warming products by misuse, abuse, improper care, accident,
normal wear and tear, use of non-mobile warming battery systems, and or the natural breakdown of
materials over an extended period of time and use are not covered in this warranty. Any alterations or
repairs (attempted or otherwise) performed on any Mobile Warming product voids any and all
warranties offered by Mobile Warming for that particular item. Mobile Warming products are technical
athletic apparel and is not intended for use as work wear or for use in strenuous or demanding
circumstances or extreme conditions.
How to initiate a Warranty Claim
First, please ensure that your product is covered under warranty according to the terms above. Then
simply have a digital copy of your dated proof of purchase ready and contact our friendly customer
service team at [email protected], informing us that you would like to initiate a warranty claim
for repair, briefly explaining the nature of your claim, with your dated proof of purchase attached. Our
customer service team will then follow up with you within two business days of receiving all of the
necessary information with an email containing a Return Authorization number, return instructions and
the return shipping address in order to return with your defective item.
To wash, disconnect the battery(s) from the power lead/wire harness, and
remove battery from garment(s).
Machine Wash Cold Only
Lay flat air dry only. Do not machine dry.
Do Not Bleach. Do Not Iron, Do Not Dry Clean, Do Not Tumble Dry, Do
Not Wring.