Mocka Teepee User manual

ABC
x1
Cotton String
(130cm)
metal pole
(top)
metal pole
(bottom)
x5 x5
Hardware Supplied
WARNING: KEEP AWAY FROM FIRE/FLAME
ASSEMBLY OF THIS ITEM SHOULD BE PREFORMED BY AN ADULT ONLY
Teepee
1
mocka.co.nz | mocka.com.au
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.

12
To begin assembly connect metal poles (A) and (B) together as shown.
Repeat until all five poles are assembled.
Insert five complete poles one at a time into the side channels in the tent
canvas. Ensure the metal poles (A) with hole are at the top. Slide each
pole right to the base of the canvas channel.
B
x5
1
B
x5
A
B
B
A
Teepee
2
mocka.co.nz | mocka.com.au
Assembly Instructions

12
To begin assembly connect metal poles (A) and (B) together as shown.
Repeat until all five poles are assembled.
Insert five complete poles one at a time into the side channels in the tent
canvas. Ensure the metal poles (A) with hole are at the top. Slide each
pole right to the base of the canvas channel.
B
x5
1
B
x5
A
B
B
A
34
Attach metal poles and tent canvas together with the cotton string (C).
Lie the teepee flat and bunch the ends together, thread the string
through the eyelets in the canvas and then through the pole -
alternating each time (keeping all poles bunched together).
Secure the string with a tight knot. Roll out the ground sheet [2] and
position the base of the five poles around the corners of the sheet.
x1
Knot
C
2
1
1
C
x1
Teepee
3
mocka.co.nz | mocka.com.au
Assembly Instructions

56
Attach the tent canvas to the ground sheet by threading the string ties
through all eyelets at the base of the canvas. Secure with a knot in
each as shown.
All done! Ensure all teepee poles are fully extended and the fabric in
each section is taught. The fabric should not sag between poles if all
poles are fully extended. Enjoy!
x5
x5
Teepee
Assembly Instructions
4
mocka.co.nz | mocka.com.au