Mockmill MOCK Flakes User manual

Please read the operating instructions before using your Mockmill.
This will protect you and prevent damage to your tool.
Mockmill
Flakes
for various
kitchen mixers
INSTRUCTION MANUAL
DE
EN

T
A
S
T
E
S
B
E
T
T
E
R
FRESHLY
FLAKED
GRAINS
A
N
D
W
H
O
L
E
S
O
M
E
HOME-MADE
FOOD IS GOOD
FOR YOU
J
U
S
T
T
R
Y
I
T
FRESH
FLAKED
AROMA
TASTE -FEEL -EXPLORE
get the most out of grains

JOIN THE
FOOD
REVOLUTION
3
Dear Customer,
we are very pleased that you have purchased one of our Mockmills
and welcome you to the world of cereals:
Taste: Freshly flaked tastes better.
Feel: Homemade is good for you and easy to digest.
Explore: Quality you make yourself, quite simply!
Try out your Mockmill right away and enjoy the variety,
the great taste and the full aroma of freshly flaked whole grains.
We hope you will enjoy discovering and enjoying of
new individual creations.
We also look forward to your feedback.
Kind regards
Paul Lebeau und Martina Mock
Good to have you with us!
DE
EN

4

5
Content
Welcome ___________________________ Page 3
Precautions and safety instructions _________ Page 6
Operating elements ____________________ Page 8
Assembly / Preparation _________________ Page 9
Getting started ______________________ Page 10
Opening and cleaning __________________ Page 11
What can I flake with the Mockmill Flakes? ____ Page 18
Any questions? _______________________ Page 19
Technical data and scope of delivery ________ Page 20
Warranty, repair ______________________ Page 21
Your notes __________________________ Page 22
Contact ____________________________ Back cover
DE
EN

6
PRECAUTIONS
AND SAFETY INSTRUCTIONS
Before using your Mockmill
for the first time, please read
this section carefully.
Selection of grains
Use only cleaned grains. Unclean
grains may contain small stones
that can damage the rollers.
Flaking grains other than
listed on page 18 may damage
the machine and invalidate the
warranty. The range of possibi-
lities is enormous, so for advice
on using other grains, please
contact us via email:
[e-mail]
For home use
To avoid overheating your mixer,
let it rest after flaking one full
hopper of grains. As a general
rule, one should let the mixer
cool down for about 45 minutes
before continuing. Check your
mixer’s manual for more
specific instructions.

7
Supervision
The Mockmill may only be
operated under proper super-
vision (and not by children).
Warning
Never reach into the milling
rollers or insert any objects (e.g.
spoons, screwdrivers) when the
appliance is switched on. Failure
to observe this warning may
result in injury (such as injury
to fingers), and damage to the
rollers could occur.
Cleaning
Dismount the flaker from the
mixer before cleaning. The unit
must never be allowed to get wet.
Above all, never immerse it in
water or other liquids. Simply
wipe the outside of the housing
very lightly with a damp cloth.
DE
EN

8
COMPONENTS
A: Housing closure
B: Funnel
C: Drive shaft
D: Alignment pin
E: Fastening screw
F: Housing with scale
G: Adjustment slide B
A
F
C
D
E
G

9
ASSEMBLY / PREPARATION
1. Loosen the fastening screw and remove the mixer’s attachment
hub cover.
2. Insert the Mockmill into the attachment hub,
aligning the drive shaft with the square hub socket.
3. Rotate the attachment back and forth to find the fit if necessary.
4. When the Mockmill is properly seated, the alignment pin on
the Mockmill will fit into the notch on the hub rim.
5. Tighten the extra-long fixing screw provided until the Mockmill
is securely attached to the mixer.
Exception: KitchenAid Mini
Please use the original KitchenAid screw.
C
D
E
DE
EN

10
Before first use
Flake a handful of oats and then throw the flakes away. By doing this,
you remove from the rollers any possible manufacturing residues.
Getting started - please follow in order
Verify that the Mockmill is firmly seated on the mixer.
Then you are ready to start!
1. Setting the thickness: Simply slide the funnel to the desired position,
the scale indicates the position for thicker or thinner flakes.
2. Load your cereal /seeds into the hopper.
3. Set the mixer to “3” for flaking.
4. Switch off after the desired amount of flakes has been produced.
Cleaning / sticky rollers
If the machine is to be left standing for a long time, e.g. before a
holiday, we recommend that you clean the rollers. This is very easy
(see next page). See also the demo video on our website at:
www.mockmill.com
⟶Service/Help ⟶ Help/Support.
GETTING STARTED

11
OPENING AND CLEANING
If your flaker unit is stubbornly dirty, it may be useful to open it up.
Then you can clean the flaking unit and remove grain residues
from the housing with a soft brush or a wooden spatula.
Proceed as follows:
If necessary, remove the Mockmill from the mixer
(page 9) and pull the funnel out of the adjustment slide.
1
DE
EN

12
Carefully remove the dome shaped casing closure. To release it,
move the adjustment slide using one finger. You will feel some
resistance; carefully increase the force until the closure
is released.
2
Adjustment slide

13
Stand the Mockmill upright, grasp the outer casing
with both hands and push it down onto the table.
Now hold the drive flange with one hand and pull the
cylindrical housing away with the other hand.
3b
3a
DE
EN

14
4b
Now push the adjustment slide towards the flange side (4a),
then lift it up and out (4b, 4c).
4a

15
4c
Now you can clean the rollers with a coarse brush and remove
any residue you find among the gears.
5
Rollers
DE
EN

16
Guide groove
To reassemble, simply proceed in reverse.
Take special care that when mounting the round housing
cylinder, the guide groove (6b) slides into the tongue (6a).
Tongue
6b
6a

17
When mounting the housing lock, make sure that it is
correctly aligned. The guide groove of the housing lock and
the tongue of the inner plate are marked accordingly.
Guide groove Tongue
7
DE
EN

18
Readily flaked
Disrupted for bio-
availability Requires preparation*
Oats Golden millet, quinoa, brown
millet, hemp seeds, sesame
seeds, linseeds, buckwheat
Einkorn, Naked Barley,
Buckwheat
WHAT CAN I FLAKE WITH THE MOCKMILL?
Grain table for flaker attachment Mockmill Flakes
* Briefly soak the grains in a kitchen sieve and then place them on a towel to dry.
Once dry, they can be flaked.

19
FURTHER INSTRUCTIONS FOR USE
On our website at: www.mockmill.com ⟶
Service/Help ⟶ Help/Support you will find videos
for further application notes.
Troubleshooting
In the unlikely event that you experience a problem with your
Mockmill or should you have any questions as to how it works,
please contact us by phone [phone]) or email
[e-mail]. Almost all problems can be solved
by our technical staff by phone.
DO YOU HAVE
ANY QUESTIONS?
Our hotline:
[phone]
[e-mail]
MADE IN
GERMANY
DE
EN

20
Description:
Flaker attachment
Mockmill Flakes
Suitable for kitchen
machines of the brands:
Electrolux (some models),
KitchenAid (all models),
Kenmore (some models).
Fineness:
Adjustable for desired flake
thickness.
Flaking throughput:
120 g per minute
(thin flakes and with the mixer
set at 3).
Hopper capacity:
600 g
Crushing mechanism:
Plastic
Housing:
Plastic
Dimensions:
27x10.5x18 cm
Weight:
1,2 kg
Warranty:
2 years
Colour:
White
Contents of delivery:
Flaker attachment with funnel, extra-long fastening screw,
operating instructions.
Technical changes reserved.
TECHNICAL DATA AND CONTENTS