Modena PZ 3270 Owner's manual

User
Manual Book
Pizza Counter
PZ 3270, PZ 2170

2
Thank you for your trust in choosing MODENA products for your household needs. With your
satisfaction as our priority, we constantly aim to deliver stylishly designed products equipped
with state-of-the-art technology to assist you in your daily activities.
This is your guidebook containing everything you need to know about our product. Please reach
out to us if you need further assistance or other information via our Customer Care or our
official website www.modena.com.

3
CONTENTS
Page
INTRODUCTION
2
-
Part 1
: Name of Parts
4
-
Part 2
: Installation
4
-
Part 3
: How to Use
5
-
Part 4
: Cleaning & Maintenance
6
-
Part 5
: Specification
7

4
The picture is a general overview and is not necessarily the same as the product you receive.
Features and completeness depends on the type of products
Important safety information
1. To obtain full use of the cabinet, please read this manual book carefully.
2. It is the user’s responsibility to operate the appliance in accordance with the instructions given.
3. Contact MODENA Call Center immediately in case of any malfunctions.
4. Place the cabinet in a dry and ventilated place.
5. Keep the cabinet away from strongly heat-emitting sources and do not expose it to direct sunlight.
6. Always keep in mind that all electrical devices are sources of potential danger.
7. Do not store inflammable material in the cabinet, such as thinner, gasoline etc.
8. MODENA declares that no asbestos nor any CFC are used in the construction.
9. The oil in the compressor does not contain PCB.
Unpacking and installation
Remove the wooden pallet and the packaging. External surfaces are packed with a
protection foil, which must be removed before installation.
To ensure correct function it is important that the cabinet is level. The cabinet is supplied with legs,
these can be adjusted. (See Picture 1.1)
If you want to build your cabinet please note the following:
There must be at least 15 cm free space above the cabinet in order for the cooling system to work
optimally.
There must be sufficient space at the hinge side to clean and replace the shelves.
Electrical connection
The cabinet operates on 230 V/50 Hz.
Part 1: Name of Parts
Part 2: Installation
Picture 1.1

5
The wall socket should be easily accessible.
All earthing requirements stipulated by the local electricity authorities must be followed. The cabinet power plug
and wall socket should then give correct earthing. If in doubt, contact your local supplier or authorized technicians.
The flexible wire fitted to this appliance has three cores for use with a 3-pin 13-Amp or 3-pin 15-Amp plug. If a B.S.
1363 (13-Amp) fused plug is used, it should be fitted with a 13-Amp fuse.
The wires in this mains lead are colored in accordance with the following code:
Green/Yellow: Earth
Blue: Neutral
Brown: Live
The electrical connection must be performed by the authorized technicians.
Start-up of the cabinet
Before the use, MODENA recommend that the cabinet is cleaned, see the section on
cleaning and maintenance.
IMPORTANT!
If the cabinet has been horizontally placed during transport, please wait for 2 hours
before starting up the cabinet.
Remember to remove the transport safety device on the compressor. Remove the
whole bar as shown in Picture 1.8.
Connect the cabinet to the power socket and turn on the switch on the control panel,
see Picture 1.9.
Thermostat
The thermostat is placed in the control panel, see Picture 2.0.
The thermostat has been pre-set and in most cases it is not necessary to adjust the settings.
When turning on the cabinet, the display will show the current temperature in the cabinet.
Display set temperature:
Press this button and the display will show the set temperature. Press the button again to return to
normal reading.
Set new temperature:
Press this button continuously for more than 3 seconds and the display shows the set temperature.
Press this button to increase the set temperature.
Press this button to lower the set temperature.
Part 3: How to Use
Picture 1.8
Picture 1.9
Picture 2.0

6
Press this button to save the new settings. The display will flash with the new value and will then
return to normal reading.
Alarm codes:
“P1‟ Flashing in the display: indicates that the cabinet sensor is defective.
The cabinet will strive to keep the set temperature until it has been repaired.
“P2‟ Flashing in the display: indicates that the evaporator sensor is defective.
This does not influence the operation of the cabinet, but should be repaired as soon as possible.
Defrosting
The cabinet defrosts automatically with pre-set intervals. If the door to the cabinet is opened or the contents of the
cabinet are changed frequently it may become necessary to defrost the cabinet manually.
Pressing this button continuously for more than 3 seconds will start a manual defrosting and then
return to normal operation.
Defrosted water runs to a container placed in the compressor compartment and evaporates.
Cleaning & maintenance
Disconnect the appliance from the socket.
The cabinet must be periodically cleaned. Clean the external and internal surfaces of the cabinet with a light soap
solution and wipe it dry. External surfaces can be maintained using steel oil.
Remove the condenser filter (see Picture 2.1), and clean it with a vacuum
cleaner and if necessary a light soap solution.
DO NOT use cleansers containing chlorine or other harsh cleansers, as these can
damage the stainless steel surfaces and the internal cooling system.
Clean the condenser and the compressor compartment using a vacuum cleaner
and a stiff brush.
DO NOT hose the compressor compartment with water as this can cause short
circuits and damage on the electrical parts.
Service
The cooling system is a firmly sealed system and does not require supervision, only cleaning. If the cabinet fails to
cool, check if the reason is a power outage.
If you cannot find the reason to the failure, please contact MODENA Call Center and inform model and serial
number of the cabinet which is placed inside the cabinet at the top right hand side.
Disposal
Disposal of the cabinet must take place in an environmentally correct way. Please note existing regulation on
disposal. There may be special requirements and conditions which must be followed.
Part 4: Cleaning & Maintenance
Picture 2.1

7
The refrigeration temperatures is for the normal environment. They are different from region to region.
Specifications of this appliance may change without notice to improve the quality of the product. Figures in this
manual are schematic and may not match your product exactly.
Pictures in this manual book are schematic and may not match your product exactly. Values stated on the
appliance label orin the documentation accompanying it are obtained in laboratory in accordance with the relevant
standards. Depending on operational and environmental of the appliance, values may vary.
PIZZA COUNTER PZ 3270
PIZZA COUNTER PZ 2170
2 Doors
1 Door
7 drawers
7 drawers
Electronic thermostat
Electronic thermostat
Digital LED temperature display
Digital LED temperature display
Capacity : 428 liters
Capacity : 221 liters
Power : 350 W
Power : 350 W
Voltage / Frequency : 230 V / 50 Hz
Voltage / Frequency : 230 V / 50 Hz
Temperature : +2°C ~ +8°C
Temperature : +2°C ~ +8°C
Internal dimension 945*680*560 mm
Internal dimension 435*680*560 mm
Product dimension 2025*800*1000 mm
Product dimension 1510*800*1000 mm
Part 5: Specification

11/20