Modern Fan Co Cirrus Flush User manual

THE MODERN FAN COMPANY
Customer Service
M-F 8am - 4pm (PST)
(ph) 888.588.3267
www.modernfan.com
(1) Remove and identify contents of carton.
Cirrus Flush Fan- Installation instructions
Should you have any questions or difficulty installing your new fan,
please contact Modern Fan Co. customer service immediately.
Note: Power supply must be turned off prior to any contact with electrical wires. It is
recommended that a licensed electrician be hired to install your ceiling fan.
Cirrus Flush
optional control
balancing
kit
blades
hardware
package
fan body
bottom dome
ceiling
plate
(2) Using the existing screws from your junction
box, or the machine screws from the hardware
package, secure the ceiling plate to ceiling
junction box. The electrical wire must be
accessible through the hole in the center of the
ceiling plate.
(3) Secure suspension cable loop around the hook inside
the top of the fan body.
hook
With fan suspended by cable, make wire connections with
wire nuts included in hardware package as described in the
control installation instructions. If using the optional #003,
#004 or #005 control, the receiving unit should be placed
inside the top of the fan and connected at this time.

(4) Lift fan body and carefully align collar with
ceiling plate. Tabs on ceiling plate should seat
into channel on inside of fan collar. Rotate fan so
that set screw holes on fan body align with set
screw holes on ceiling plate.
(5) Insert and firmly tighten three set screws.
Note- Do not tighten down set screws until all three are
partly screwed in.
(6) Carefully insert blades into rotor slots, and using pan
head screws from hardware package, secure blades to
rotor.
set screw hole
(7) Install bottom dome by rotating in the clock wise
direction, or if using an optional light, proceed to step (8).
(8) To install optional light kit, begin by identifying all parts. Then follow
steps (a) through (e):
glass
socket
hardware
ring
stickers
(a) Connect wire leads from the
fan to the socket, and using
screws from hardware package,
attach socket bracket to switch
housing.
(b) To prevent escape of light into rotor
area, apply reflective stickers to switch
housing plate, covering blade screw slots.

(c) Move the light switch to the “ON” position.
(d) Align holes on side of ring with holes
on switch housing plate. Secure using small
countersink screws and screwdriver from hardware
package. Start all three screws before tightening
completely.
(e) Install lamp. Then align channels/grooves on
glass diffuser with tabs on ring and rotate glass
until firmly tight. Do not over tighten.
(11) The rotor and motor of your fan have been dynamically balanced at the factory.
In addition, the blades have been matched to the nearest gram to ensure a well
balanced ceiling fan. Furthermore, a blade balancing kit has been included with your
fan. Please refer to the instructions packaged with the balancing kit should your fan
require additional balancing.
(10) Install wall control as described in the control installation instructions (unless
using handheld remote only).
(9) Your fan is reversible for summer and winter operation.
The reverse switch is located on the side of the switch
housing. The LEFT position is for summer and the RIGHT
position is for winter.
reverse switch
709 Washington Street • Ashland, OR 97520 • (tel) 888.588.3267 • (e) [email protected]
w w w . m o d e r n f a n . c o m