Modern Fan Co Velo Flush User manual

THE MODERN FAN COMPANY
Customer Service
M-F 8am - 4pm (PST)
(ph) 888.588.3267
www.modernfan.com
(1) Remove and identify contents of carton.
Velo Flush Fan- Installation instructions
Should you have any questions or difficulty installing your new fan,
please contact Modern Fan Co. customer service immediately.
Note: Power supply must be turned off prior to any contact with electrical
wires. It is recommended that a licensed electrician be hired to install your
ceiling fan.
Velo Flush
balancing
kit
mounting plate
blades
hardware
package
bottom cap
fan body
optional
control
(2) Using machine screws from hardware package
or existing screws in junction box, securely attach
mounting plate to ceiling junction box.
(3) Using blade screws from hardware package,
secure blades to rotor arms.

(5) With fan safely suspended by cable, make wire connections with wire
nuts included in hardware package as described in the Control Installation
Instructions. If using optional #003, #004 or #005 controls, the receiving
unit should be placed inside the top of the fan and connected at this time.
(4) Suspend fan from mounting plate using security cable loop and
washer hook.
security cable
washer hook
(6) Lift fan body and carefully align collar with
ceiling plate. Tabs on ceiling plate should seat
into channel on inside of fan collar. Rotate fan
so that set screw holes on fan body align with
set screw holes on ceiling plate.
(7) Insert and firmly tighten three set screws.
Note- Do not tighten down set screws until all
three are partly screwed in.
set screw hole
(8) If installing a light kit, proceed to step (9).
Otherwise, install bottom cap by rotating clockwise
until firmly attached.
(9) To install optional light, begin by identifying
parts. Then follow steps below.
glass diffuser
LED module
(a) Use quick
connects to join wire
leads from LED to
wire leads from fan.
(b) Postition wires
inside light cup and
using screws on the
fan body, attach to
fan. Be sure wires
are clear of edges.
(c) Attach glass
shade by aligning
slots on glass with
posts on fan. Rotate
clockwise to secure.

(10) Install optional wall control as described in the control installation
instructions (unless using handheld remote control only).
(12) The rotor and motor of your fan have been dynamically balanced at
the factory. In addition, the blades have been matched to the nearest
gram to ensure a well balanced ceiling fan. Furthermore, a blade balancing
kit has been included with your fan. Please refer to the instructions
packaged with the balancing kit should your fan require additional
balancing.
(11) Your fan is reversible for summer and winter
operation. The reverse switch is located on the
side of the fan body. When reading the
REVERSE label, the LEFT position is for summer
and the RIGHT position is for winter.
reverse switch
709 Washington Street • Ashland, OR 97520 • (tel) 888.588.3267 • (e) [email protected]
w w w . m o d e r n f a n . c o m