modway EEI-3427-NAT-WHI User manual

EEI-3427-NAT-WHI SOFA
Customer Service 908-368-1025︱www.modway.com Page 1 of 3
Hardware:
Component:
Thank you for purchasing the MODWAY SOFA!
Before you start, here are some helpful advice:
3
4
1
2
1. Chair Back
3. Left Frame
4. Right Frame
7. Cushion Back
5. Middle Front &
Rear Legs
6. Seat Cushion
2. Chair Seat
x2
x1
x1
x1
x1
x1
x2
5
6
7
A Bolt M6x50mm
x 10
DAllen Wrench M4 x 1
BScrews x 4
CScrewdriver x 1
We suggest you spend a short time reading through this leaflet and then follow the simple
step by step instructions.
Owing to the size and weight of the sofa, we recommend that it is assembled by two adults,
on a carpeted or padded area, in the room that it is intended for. Approximate assembly
time: 30 minutes.
Please do not use any tools other than those provided or recommended in these instructions.
Please do not throw away any of the packaging or instructions until you have checked all
the components and hardware and the furniture is fully assembled.
Assemble all components loosely until advised to tighten. Depending on use, it may be necessary
to tighten the components from time to time, so please save the tools that have been provided.
Please keep all pieces out of reach of small children.
1.
2.
3.
4.
5.
6.

EEI-3427-NAT-WHI SOFA
Customer Service 908-368-1025︱www.modway.com Page 2 of 3
- Insert the rabbet on the Left Frame (3) into the tenon on Chair Seat (2) and Chair Back (1) at first.
- Repeat the same steps for the Right Frame (4).
Please assemble Sofa Seat first including the Support Wooden.
3
4
1
2
STEP 1:
STEP 2:
- Repeat the same steps for Left Frame (3).
- Roll the sofa to the front to attach the Front Middle Leg (5). Then insert 2 pieces of Screws (B),
into the pre-drilled holes on Sofa Seat (2), Tighten it with Screwdriver (C).
- Roll the sofa to the back to put the Middle Leg Back (5) Then insert 2 pieces of Screws (B),
into the pre-drilled holes on Sofa Seat (2), Tighten it with Screwdriver (C).
- Insert 3 pieces of Bolt (A) into the pre-drilled holes on Chair Back (1), and Chair Seat (2),
through the top pre-drilled holes on Right Frame (4). Use Allen Wrench (D) to tighten Bolts (A) clockwise until secure.
2
1
4
3
Front/Back
Legs Middle
B
B
5
A x 10
Dx 1
Bx 4
Cx 1
C
Hardware & Tool required
1
1
2
2
3
3

EEI-3427-NAT-WHI SOFA
Customer Service 908-368-1025︱www.modway.com Page 3 of 3
STEP 4:
Carefully position the assembled chair to the desired location.
Put Seat Cushion (6) and Back Cushion (7) into the assembled chair as shown.
Assembly is complete. Your Sofa is ready to be used now!
6
7
STEP 3:
- Insert 4 pieces of Bolt (A) into the pre-drilled holes on Chair Back (1).
1
2
3
4