modway EEI-3708-NAT-TAU User manual

A
D
Bolt M6x90mm x 4
Allen Wrench M4 x 2
2. Back Slat 2(without Hole)
3. Seat
x2
x1
Hardware:
Component:
Page 1 of 4
Thank you for purchasing the MODWAY DINING CHAIR!
Before you start, here are some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the dining chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.
Customer Service 609-256-9000 www.modway.com
1. Back Slat 1 (with Holes) x1
1
3
5
BNut M6 x 4
Screw M6x50mm x 2
C
EEI-3708-NAT-TAU DINING CHAIR
2
4. Leg Frame x2
5. Seat Cushion x1
4

Page 2 of 4
STEP 1:
Hardware & Tool required
STEP 2:
Hardware & Tool required
Customer Service 609-256-9000 www.modway.com
4
3
DB
FD
C
A
EEI-3708-NAT-TAU DINING CHAIR
D
1
x2
A
x2
D
x2
B
Attach Back Slat (1) to Leg Frame (4) as shown.
Then insert 1 piece of Screw (C) through Leg Frame (4) into Top Back (1).
Tighten with Allen Wrench (D).
x1
C
x1
D
Attach Leg Frame (4) to Seat (3) as shown.
Insert 2 pieces of Nuts (B) into Seat (3),then insert 2 pieces of Bolts (A) through Leg Frame (4) into Seat (3).
Tighten with 2 pieces of Allen Wrench (D).

Page 3 of 4
STEP 3:
Hardware & Tool required
STEP 4:
Customer Service 609-256-9000 www.modway.com
EEI-3708-NAT-TAU DINING CHAIR
Hardware & Tool required
FD
C
2
x2
A
x2
D
x2
B
Insert 1 piece of Screw (C) through Leg Frame (4) into Back Slat 1 (1).
Tighten with Allen Wrench (D).
x1
C
x1
D
Attach other Leg Frame (4) to Back Slat 1 (1), Back Slats 2 (2) and Seat (3) as shown.
Insert 2 pieces of Nuts (B) into Seat (3),then insert 2 pieces of Bolts (A) through Leg Frame (4) into Seat (3).
Tighten with 2 pieces of Allen Wrench (D).
DBA
D

Carefully position the assembled dining chair to the desired location.
Put the Seat Cushion (5) into the assembled dining chair as shown.
5
EEI-3708-NAT-TAU DINING CHAIR
Page 4 of 4
STEP 5:
Assembly is complete. Your dining chair is ready to be used now!
Customer Service 609-256-9000 www.modway.com