modway EEI-4224 User manual

EEI-4224 CORNER
Customer Service 609-256-9000︱www.modway.com
Page 1of 2
Thank you for purchasing the MODWAY CORNER.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the corner, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.
Hardware:
Components:
Bolt M6x20mm x4
1. Top Rail x1 2. Left Leg x1 3. Right Leg x1 4. Seat Frame x1
A.
Allen Wrench x1
C.
Bolt M6x25mm x6
B.
5. Seat Cushion x1 6. Back Cushion x1 7. Side Cushion x1

EEI-4224 CORNER
Customer Service 609-256-9000︱www.modway.com
Page 2of 2
STEP 1:
1. Remove the plastic covers which pre-install at the end of the Seat Frame (4) by using Allen Wrench (C).
2. Please put the Left Leg (2) on a carpeted or padded area as shown.
3. Insert the Top Rail (1) into the Left Leg (2) as shown.
4. Insert the Seat Frame (4) into the Left Leg (2) as shown with Figure.
Note: The bottom of the Seat Frame (4) and Left Leg (2) is marked with Front. Abt. 3cm from the
top of the seat to the top of the seat back rail and 1.5cm for the seat front.
5. Insert 3 pieces of Bolts (B) from the pre-drilled holes on the bottom of the Top Rail (1) and the Seat Frame (4)
into each side on the bottom of the Left Leg (2).
6. Insert 2 pieces of Bolts (A) from the pre-drilled holes on the side rail of the Seat Frame (4) into each end of
the Left Leg (2) as shown. Do not fully tighten Bolts (A&B) at this step.
7. Repeat the same steps for the Right Leg (3).
8. After checking the leveling for all connections, please use Allen Wrench (C) to tighten all Bolts (A&B)
clockwise until secure.
STEP 2:
1. Carefully place the assembled chair at your desired location.
2. Put the Seat Cushion (5),Back Cushion (6), and Side Cushion (7) to assembled corner as shown.
Assembly is complete. Your corner is ready to enjoy now!