modway EEI-4122-NAT User manual

EEI-4122-NAT COFFE TABLE
Thank you for purchasing the MODWAY COFFE TABLE!
Before you start, here is some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe ,
environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time,so please save the tools that have been provided.
6. Please keep all fitting out of reach of children.
Hardware:
A BoltM8x6cm x8
Component:
1 Table Top x1 2 Leg x4
︱︱︱Customer Service 908 368 1025 www.modway.com Page 1 of 2 - -
1
2
2
2
2
B
C
Spring Washer M8 x8
x1

STEP 2:
Carefully turn over the assembled table.
Assembly is complete. Your chair is ready to be used now!
︱︱︱Customer Service 908 368 1025 www.modway.com Page 2 of 2 - -
Hardware & Tool required
Ax8 Bx8 Cx1
STEP 1:
Please put the Table Top (1) upside down on a carpeted or padded area.
Position 1 piece of Leg (3) into the corner of Table Top (1) as shown.
Insert 2 pieces of Bolt (A) with 2 pieces of Flat Washer (B) into the pre-drilled holes on
bottom of Leg (2) through the pre-drilled holes on Table Top (1) .
Repeat the same steps for the remaining Legs (2).
Use Open Wrench (C) to tighten Bolts (A) clockwise until secure.
EEI-4122-NAT COFFE TABLE