modway SUNBED EEI-2250 User manual

Customer Service 609-256-9000︱www.modway.com Page 1 of 2
EEI-2250 SUNBED
Hardware:
Component:
ABolt M6x20mm x4
B
CAllen Wrench x1
1 Front Leg x1
Thank you for purchasing the MODWAY SUNBED！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the bed, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
3
1
Bolt M6x25mm x4
2Lounge Back x1 3Back Leg x1
2

Customer Service 609-256-9000︱www.modway.com Page 2 of 2
EEI-2250 SUNBED
STEP 1:
Remove the plastic covers which pre-install in the end of side rail on the Lounge Back (2) by using Allen Wrench (C).
Please put Lounge Back (2) and Back Leg (3) upside down on a carpeted or padded surface as shown.
Insert Lounge Back (2) into Back Leg (3) as shown by two adults.
Insert 2 pieces of Bolts (B) from the pre-drilled holes on the bottom of the Lounge Back (2) into each side
on the bottom of Back Leg (3) as shown.
Insert 2 pieces of Bolts (A) from the pre-drilled holes on the side rail of the Lounge Back (2) into each end of Back Leg (3) as shown.
Do not fully tighten Bolts (A&B) at this step.
Repeat the same steps for Front Leg (1).
After checking the leveling for all connections, please use Allen Wrench (C) to tighten all Bolts (A&B) clockwise until secure.
STEP 2:
Assembly is completed. The bed is ready to enjoy now!
Carefully place the assembled bed at your desired position.