modway EEI-3698-NAT-LGR User manual

A
B
Screw M6x70mm x 2
Screw M6x40mm x 2
x1
x2
EEI-3698-NAT-LGR CHAIR
Hardware:
Component:
Page 1 of 3
Thank you for purchasing the MODWAY CHAIR!
Before you start, here are some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.
Customer Service 609-256-9000 www.modway.com
x1
1
2
3
4
x1
D
5
6
1. Back
2. Seat
3. Leg Frame
4. Back Rail
5. Crossbar
x1
6. Back Cushion x1
GAllen Wrench M4 x 2
E
Bolt M6x90mm x 4
F
Bolt M6x70mm x 2
Nut M6 x 6
CScrew M4x15mm x 2
7
7. Seat Cushion x1

EEI-3698-NAT-LGR CHAIR
Page 2 of 3
Hardware & Tool required
Hardware & Tool required
Customer Service 609-256-9000 www.modway.com
3
3
5
G
E
G
A
2
x6
F
F
F
D
G
4
1
x2
A
x1
G
x4
D
x2
G
x2
E
F
D
G
STEP 1:
Attach 1 piece of Leg Frame (3) to the Back (1), Back Rail (4) and Crossbar (5) as shown.
Then insert 2 pieces of Bolts (D) and 1 piece of Bolt (E) through Back (3) into Leg Frame (3).
Use Allen Wrench (G) to tighten Bolts (D&E).
Repeat the same steps for the remaining Leg Frame (3).
STEP 2:
Attach Seat (2) to LegsFrame (3) and Back (1) as shown.
Then insert 2 pieces of Screws (A) through Seat (2) into Legs Frame (3).
Use Allen Wrench (G) to tighten Screws (A).

x2
B
EEI-3698-NAT-LGR CHAIR
Page 3 of 3
STEP 3:
Hardware & Tool required
Customer Service 609-256-9000 www.modway.com
x1
GG
B
6
x2
C
C
4
1
Assembly is complete. Your chair is ready to be used now!
Carefully position the assembled chair to the desired location.
Put 1 piece of the Back Cushion (6) and 1 piece of the Seat Cushion (7) into the assembled chair as shown.
STEP 4:
Screw Driver (Not provided)
Insert 2 pieces of Screws (C) through Back Rail (4) into Back (1). Tighten with Screw Driver (Not provided).
Insert 2 pieces of Screws (B) through Seat (2) into Back (1). Tighten with Allen Wrench (G).
7