modway EEI–163 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2
EEI–163 CHAIR
Thank you for purchasing the MODWAY CHAIR！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe and
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all fitting out of reach of children.
Hardware:
A
C Allen Wrench M5 x1
Component:
1 Chair Top x1 3 Seat Cushion x1
Bolt M6x25mm x4
1
B Nut M6 x4
D Open Wrench M5 x1
2 Chair Base x1
2
3
LOUNGE

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
STEP 1:
STEP 2:
Put Chair Base (2) on a carpeted or padded surface.
Place Chair Top (1) to Chair Base (2) as shown.
Insert 4 pieces of Bolt (A) into the pre-drilled holes on Chair Base (2) through the pre-drilled holes on Chair Top (1) .
Secure 4 pieces of Nuts (B) to each piece of Bolt (A) as shown.
Use Allen Wrench (C) and Open Wrench (D) to fully tighten Bolts (A) and Nuts (B).
Carefully place Seat Cushion (3) to the assembled Chair Top (1) and Chair Base (2) as shown.
Assembly is complete. Your is ready to be used now!
1
2
3
Hardware & Tools required
Ax4 Dx1 Bx4 Cx1
1
2
B
B
B B D
A A A A
C
EEI–163 CHAIR
LOUNGE
Lounge Chair