modway MOD-5478 User manual

8
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the bed, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
Bolt
i Bolt
Bolt
Bolt
Allen
Side Slat
Single
Rail
5478
i i
Rail

Place Center Rail (7) and 4 pieces of Support Leg (6) under assembled Double Slat (4) and Single Slat (5) as shown.
Insert 4 pieces of Long Bolt (C) into the 4 holes right on Center Rail (7) to connect it with Support Legs (6) as shown.
Insert 4 pieces of Medium Bolt (B) into 4 other holes left on Center Rail(7) to connect it with Support Legs (6) as shown.
Secure the above 8 pieces of Bolts (B&C) with Nuts (E) from the bottom of Support Legs (6) at same time.
Use Allen Wrench (G) and Open Wrench (H) to tighten all Bolts (B&C) and Nuts (E) until secure.
5478
Take out all Double Slats (4), Single Slats(5) and Side Rails(3) and place them as shown.
Insert one end of Single Slats (5) into Rubber Insert (F), then insert them into the corresponding holes on one piece of
Side Rail (3) as shown.
Attach Double Slats (4) to the same Side Rail (3) by using Short Bolts (A).Do not fully tighten Short Bolts (A) with
Allen Wrench (G) yet.
Repeat above for the other Side Rail (3).
Use Allen Wrench (G) to tighten all Short Bolts (A) clockwise until secure.
i i

Assembly is completed. Your bed is ready to be enjoyed now!
5478
G
G
ii
G
Place the Headboard (1) close to the assembled
Insert the connector on the Side Rail (3) as shown,then insert them into the corresponding holes on
1
3
3
2
Side Rail (3).
Headboard (1) into the
Side Rail (3) by using Short Bolts (D).
Repeat the same steps for the Footboard (2).