modway EEI-2140 User manual

Component:
1 Back Cushion x1 4 Leg x4
Thank you for purchasing the ARMLESS SOFA!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the sofa, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 15 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
4
2
4
3
2 Seat Cushion x1
1
4
3 Sofa Body x1
ARMLESS SOFA
Page 1 of 3

Protect film
Velcro
STEP 1:
STEP 2:
4
4
4 4
3
Carefully turn over the assembled Sofa Body (3) as shown.
Tear off the Protect film which attach onto the Velcro at first.
Then place the Back Cushion(1) and Seat Cushion (2) to the assembled Sofa Body (3) as shown.
Attach the Seat Cushion (2) by using Velcro.
3
1
2
3
Put the Sofa Body (3) upside down on a carpeted or padded area by two adults to make fully visible the corners.
Position one of Legs (4) at one of the four bottom corners.
Screw the Leg (4) into the bottom of Sofa Body (3) as shown.
Repeat the same steps for the other remaining three Legs (4).
ARMLESS SOFA
Page 2 of 3

STEP 3:
If you want the armless sofa combine with other section.
Put the assembled Sofa Body (3) upside down on a carpeted or padded area.
Screw the Clip into the bottom of sofa right end by using screws.
Using a Phillips head screw driver to tighten the screws.
Repeat the same steps for the Post.
Install the Clip on the
bottom of Sofa Body
Install the Post on the
bottom of Sofa Body
STEP 4:
Please place the Left Section at your desired location.
Align the Post on the bottom of Left Section to the Clip on the bottom of Armless Sofa as shown at first.
Push the Armless Sofa close to the Left Section slowly until the Clip and the Post click together tightly.
Then align the Clip on the bottom of Right Section to the Post on the bottom of Armless Sofa.
Push the Right Section close to the Armless Sofa slowly until the Clip and the Post click together tightly.
3
Installed Clip on the
bottom of Sofa
Installed Post on the
bottom of Sofa
3
If you want to unlock the sofa. Please lift up the Armless Sofa by two people.
Left Section
Right Section
ARMLESS SOFA
Page 3 of 3